Why won t my RV slide won t go in?
It is possible there may be something wrong with the electrical supply, such as a blown fuse, bad wiring, or a weak battery. You’ll need to make sure you have enough power available for the slide out to function correctly. The slide out could also be misaligned or could be blocked by something in the way.
How to fix a stuck RV slide?
#1 – Make sure the fuse isn’t blown. Blowing the fuse for the slide-out is a common failure. If you hold the button for a split second too long, the fuse will blow in order to save the motor. Just replace the fuse and the slide-out should move properly again. (And always carry spare fuses with you!)
When to troubleshoot an RV slide out mechanism?
If you notice your RV slide room is experiencing some sort of malfunction, you may need to troubleshoot to diagnose the problem and figure out the best course of action. In order to pinpoint the proper solution, you have to first determine the type of RV slide out mechanism that’s equipped on your rig.
Where is the slide out controller on a motorhome?
For my motorhome, there are two slide out controllers attached to the “roof” of the middle basement compartment between the two main beams of the frame. One controller for the passenger side slide-out and one for the drive side slide-out. RV Masters charged $130 for the new controller and $140 for an hour of labor to install the controller.
Is there a replacement motor for a disco slideout?
All disco owners are in sympathy with you and would all say the replacement motor is worth the $. On the Disco, the driver side slide fits flush to the floor when extended. The three men are getting it over the ramp to retract. There is a replacement motor with higher torque available.
Why does my slide not retract after new motor?
After the new motor was installed, the slide still would not retract. The “square rods” connected to the motor were detached to assure the new motor was functioning. We found that power to the motor existed only when the “out” part of the slide’s in/out button was pushed. There was no power to the motor when the “in” side of the button was pushed.
If you notice your RV slide room is experiencing some sort of malfunction, you may need to troubleshoot to diagnose the problem and figure out the best course of action. In order to pinpoint the proper solution, you have to first determine the type of RV slide out mechanism that’s equipped on your rig.
For my motorhome, there are two slide out controllers attached to the “roof” of the middle basement compartment between the two main beams of the frame. One controller for the passenger side slide-out and one for the drive side slide-out. RV Masters charged $130 for the new controller and $140 for an hour of labor to install the controller.
All disco owners are in sympathy with you and would all say the replacement motor is worth the $. On the Disco, the driver side slide fits flush to the floor when extended. The three men are getting it over the ramp to retract. There is a replacement motor with higher torque available.
How do you move a slide out in an RV?
You will likely need to disengage the brake assembly in order to move the slide out. Look in your owner’s manual to find out the location of the manual override, brake assembly, and any tools needed. The only challenging part might be locating the brake assembly which you will likely need to disable in order to move the unit.
