Why is the water draining out of my spa?
Normally if a pool system is perfect, it’s sealed so that the water won’t drain out from the pump or anywhere else when it shuts off, but if there’s an air leak, it loses that seal and everything floods back to the pool. That’s another reason why your spa could drain out.
How can I get my pool water out of my spa Jets?
2) Close the valve that sends pool water to the spa. If the spa jets are on a separate pump, block it’s exhaust flow to the spa. 3) Plug all but 1 spa jet. 5) Repeat for the other jets, i.e. unplug one jet and use that plug to seal the one you just blew.
What causes the Jets in a spa to stop rotating?
Most jet issues happen to massage jets and it usually occurs when the jets stop rotating. On jets with bearings the internal part of the jet and bearings can even come out into the spa. This is usually caused by poor chemical use including water being out of balance or old water being used.
Can a jet be removed from a spa?
In most case the spa jet face can be removed without damaging the jet seal and so they can be removed under water if desired. Most jet issues happen to massage jets and it usually occurs when the jets stop rotating. On jets with bearings the internal part of the jet and bearings can even come out into the spa.
Why does my spa keep draining after use?
My spa keeps draining after use. The pool builder replaced a circuit in the IntelliTouch panel which is when this started happening. I have 2 questions: How do I get the water back into the spa (on my … read more
How do I get the water back into the spa?
I have 2 questions: How do I get the water back into the spa (on my … read more The water flows from my spa to pool to pump/filter and back to spa. Lately, when the pump is turned off, the water drains out from spa down to the same level as the pool.
My spa keeps draining after use. The pool builder replaced a circuit in the IntelliTouch panel which is when this started happening. I have 2 questions: How do I get the water back into the spa (on my … read more
What to do if your hot tub jet doesn’t turn on?
Open the union on the pump that operates the jets. Look for debris clogging the impellor or a broken impellor. 3. Make sure your water level is a minimum 3/4 of the way up your skimmer or filter housing. 4. If you have adjustable jets make sure each individual jet is in the ON position. 5.
When did I put the Jandy system on my spa?
I have a Jandy System put in Dec 2002 where I can remote control switches to a built-in hot tub…. pool/tub combination. The hot tub runs off into the … read more I turned on the spa and heater and the spa drained? Now I turned on the spa and heater and the spa drained? Now what? … read more
