Why is the rollout switch on my Raypak pool not working?
We bought a new Raypak heater this year and have had nothing but trouble with the rollout switch blowing. The pool guy installed it then we hired a plumber to put in the gas line. So first he put a gas line from the heater to the house connecting it to the main gas line ($600).
Why does my Raypak pool heater keep plugging up?
I pull the burners, gas valve, etc and flush the heat exchanger with a garden hose. The most common cause for these to plug up is running too cold of water thru them. This causes a lot of condensation in the burner chamber that causes the combustion by-products to condense out and build up inside the unit.
When does a flame roll out on a Raypak heater?
Roll out occurs when either the exchanger is sooted up, or you have one or more clogged burners. Roll out sensor is one time use, no reset and must be replaced (if it is open). Yes, my rollout sensor is currently toast and needs to be replaced. So does my wire actually….big yellow flame.
What should I do if my pool switch keeps blowing?
The pool guy installed it then we hired a plumber to put in the gas line. So first he put a gas line from the heater to the house connecting it to the main gas line ($600). Switch blows and we are told that we are not getting enough gas so we need to run a separate line from where the gas comes in and connect it to the first line ($800).
We bought a new Raypak heater this year and have had nothing but trouble with the rollout switch blowing. The pool guy installed it then we hired a plumber to put in the gas line. So first he put a gas line from the heater to the house connecting it to the main gas line ($600).
I pull the burners, gas valve, etc and flush the heat exchanger with a garden hose. The most common cause for these to plug up is running too cold of water thru them. This causes a lot of condensation in the burner chamber that causes the combustion by-products to condense out and build up inside the unit.
Roll out occurs when either the exchanger is sooted up, or you have one or more clogged burners. Roll out sensor is one time use, no reset and must be replaced (if it is open). Yes, my rollout sensor is currently toast and needs to be replaced. So does my wire actually….big yellow flame.
The pool guy installed it then we hired a plumber to put in the gas line. So first he put a gas line from the heater to the house connecting it to the main gas line ($600). Switch blows and we are told that we are not getting enough gas so we need to run a separate line from where the gas comes in and connect it to the first line ($800).
