Why is the pilot light not working on my Jandy heater?

Ok, this system has a thermopile to generate the power needed to turn on the main burner gas, IF the pilot light is strong and the thermopile is good and clean and generating enough voltage, then you have a limit switch, or pressure switch or thermostat problem.

Can a LRZ heater be used in a swimming pool?

The Legacy Model LRZ electronic heater is specifically designed for heating fresh water swimming pools and spas, and with proper installation and care, they will provide years of reliable service. Do not use the heater to maintain pool or spa water temperature below 70°F (21°C).

What to do if your Jandy pool heat pump does not start?

The following provides symptoms and solutions for general troubleshooting problems for Jandy heat pumps. Heat pump will not start, no control board display. Breaker or fuse may be tripped. Reset breaker or check fuse. If heat pump still does not run, call for service.

How to troubleshoot a gas pool heater pilot light?

This step of gas pool heater troubleshooting can be difficult if there is no pattern to the pilot light extinguishing. Ensure the pilot light isn’t being forced out by wind or water. Direct sprinklers and rain spouts away from the heater or use a cover that will keep rain and snow out.

What are the parts for a Jandy pool heater?

From ignition control assemblies to heat exchangers, we have the Jandy replacement parts you need to get your pool or spa heater up and running in no time. We carry a wide selection of Jandy pool heater parts for the Lite 3, LX, LT, HI-E2, CL-3, LXI, Legacy and Hot Shot series pool heaters.

What kind of gas valve for Jandy Lite 2?

Whether you’re looking for Jandy Lite 2 pool heater parts or a gas valve for a Legacy pool heater, we have what you need and can ship it when you need it. Teledyne Laars L0032200 Gas Orifice, Natural, 0-2000 ft. Teledyne Laars L0032900 Gas Orifice, LP, 0-5000 ft.

What to do when your water heater pilot light goes out?

When the pilot light goes out, here’s how to light a gas water heater pilot light: Your first step is obvious: to try to re-light the water heater pilot light. First things first, try to light it again before assuming there is a major problem.

What to do if your pilot light wont work?

First, locate the thermocouple to clean it using a piece of sandpaper. Always remember to shut off the gas before you start cleaning and to make sure that your thermocouple is cool. If you’re thermocouple still doesn’t work after cleaning, the issue may be that it’s bent.

Can a thermocouple be bent away from the pilot light?

When it’s bent to a certain extent away from the pilot light, it’s no longer functional because it won’t be able to detect the heat. To fix this is also simple: bend the thermocouple back into its original position. Make sure to bend the thermocouple back so it’s close enough to the pilot flame so it lightly touches the thermocouple.

What makes a Jandy pool heater so good?

Providing industry-leading engineering, Jandy’s innovative line of pool heaters and heat pumps are designed to deliver quality, energy-efficient heating solutions so you can enjoy a longer swim season in your pool. The perfect pool is neither too hot nor too cold.

What’s the problem with my Laars Lite gas heater?

Am new to the forum….I have a laars lite gas heater – about 16 years old. Problem with it is as follows: With the pilot light on, I switch the heater on at the rocker. It starts up for about 10 seconds then cuts out – blows the main burners and the pilot light out.