Why is the igniter not working on my fridge?

You may have solved the problem by now, but I will relate how ours works on our Hymer.The ignition and fridge lamp are on one circuit, the battery fridge operation (engine running) is on a seperate circuit. If the fridge lamp and igniter are not working I think you have a fault with that 12 volt supply to the fridge, check where that comes from.

What should I do if my RV refrigerator is not working?

At this point, contact an RV dealer to determine which option will be the most cost-effective. Also, check to see if the unit is still in warranty. If the unit works on LP gas but not on electric or vice versa, it means the basic cooling unit is intact. Use a multimeter to check for voltage to the refrigerator.

Why is the igniter not working on my Rapido?

If the fridge lamp and igniter are not working I think you have a fault with that 12 volt supply to the fridge, check where that comes from. If the lamp is working the fault will be the the ignition switch or circuit itself. Hope this may help. Had this prob on my ’08 Rapido.

When to turn off the igniter on an RV?

Turn the igniter off when adding each component, so you don’t get a shock. If you suspect there is a problem with the signal put out by the “L” terminal, it can be tested as in the graphic below. Provide 12 volt to the “+” and “G” terminals of the igniter. Put a neon style AC tester across the “L” and “G” terminals.

What should I do if my Refrigerator igniter Sparks?

If the wire sparks to a metal part of the refrigerator, the electrode is bad. Before performing this test, however, if an electronic gas valve is involved in the system, locate the manual propane shut off valve at the back of the refrigerator and turn it off so propane is not allowed to flow and accumulate.

Why is there no spark on my igniter?

If there is no spark at the burner, first remember that the igniter senses the resistance between the burner and the electrode. If the electrode is cracked (even hairline) or wet, it will ground out and make the igniter “think” the flame is lit, and therefore not spark. The spark wire can also have similar problems.

How to troubleshoot a Dometic RV refrigerator that is not working?

Certified Mobile RV Technician, Darren Koepp, troubleshoots a Dometic RV refrigerator that is not working on propane. In this instance, the electrode wire was damaged and shorting out and therefore the burner was unable to ignite.

Why does my refrigerator make a clicking noise?

If food in your fridge is slowly beginning to spoil, you might notice the recent warm-up of your appliance is accompanied by an occasional clicking noise. The bad news is that your refrigerator is in immediate need of repairs, and the good news is that you can diagnose it pretty easily.

Is there a problem with the Dometic gas on my fridge?

Went to ignite our fridge this weekend and could’nt get it alight. It is the manual push type. It made its usual clicking noise, but would’nt ignite. There is plenty of gas, and I checked the fuse.

Why does my Refrigerator keep clicking on and off?

CHECK THE START RELAY The fans are running, so it sounds like your refrigerator is okay. But the compressor—which constricts refrigerant to cool it—is doing nothing, even though that clicking sound is supposed to be the start relay turning the compressor on and off depending on the thermostat reading.

How can I tell if my Dometic fridge igniter is out?

The 3 connectios are Positive, Negative and the lead to the Neon light on the control panel. You coudl try taking it apart and seeing if there is any obvious signs of damage. It is beginning to look like it needs repacing. As I said, normally as soon as the flame lights the sparling stops, even when the thermostat knob is pressed in.

Why does my Dometic 2 way refrigerator not light?

1) once you open the access door outside, you can see the wires that apply 12volts to the refer 2) Disreguard the use of a second person to ignite the refer, your model when turned on gas, ignites by the turning of the know 3) as it does not click, to light the ignition module is suspect

When do you need to replace spark igniter?

Replace the electrode if the ceramic insulation is broken. If the electrode is okay, you may need to replace the igniter switch or spark module. The spark igniter electrode-also called the surface burner igniter-is an insulated electrode that provides an ignition spark to light a surface gas burner.

How does the spark igniter work on an Electrolux fridge?

The spark igniter works from the 12 V leisure battery. Sometimes the spark light flashes and I hear the usual clicks as soon as I press the switch and I can start the fridge ok, but most often nothing happens for a very long time.

Why does my gas igniter keep sparking?

Most grateful for any help you can provide. Hi. If the igniter keeps sparking and the lamp flashing when the gas has lit , it can be that the spark plug tip is not in the correct position, it should be in the hottest part of the flame.

How can I Stop my Dometic fridge igniter from sparking?

Clean all earths and disconnect battery and connection plug to igniter module and sensor and clean connections. Spray the connections with switch cleaner. Then connect and disconnect the connection plugs a few times. Connect up your battery. This should stop your igniter from sparking all the time.

Why does my igniter on my fridge not work?

When it sparks no problem as it will jump the break, but the detection of the flame will not work. So might be worth while checking, if you can, the electode is joined to the wire properly under the insulation, or if you can get to the other end of the lead check with a meter.