Why is the green light not lit at Aqua rite?
We’ve been fighting this all summer and, one morning I went out to visit the outside Aqua Rite controller and found that the green “generating” light was not lit. In fact, there was only one light on…I think it was the power light and, if I remember correctly, it was red instead of green.
How to check salt level on Aqua rite PCB?
Move the switch to the Auto position. If the switch is already in the Auto or Super Chlorinate position, move it to Off then back to Auto. Wait for the relay to click, then push the diagnostics button 5 times to the instant salt level with the minus sign in front.
How to read and adjust the Hayward Aqua rite SCG?
The Hayward Aqua Rite Salt Chlorine Generator displays a total of 9 diagnostic parameters that are accessed by pushing the Diagnostic button sequentially. The default display is the Average Salt Level. If the button is not pushed for 30 seconds, the display will revert back to this salt display.
When does the aquarite turn off the chlorine?
The only exception would be if the SWG is already at 100% you will need to increase your pump run time. A typical pool only needs about four hours of pump run time. It will produce chlorine when the pump is running. When the pump goes off the Aquarite should shut down. This is going to be trial and error.
Why is my salt water chlorinator not working?
A malfunctioning salt water chlorinator is every spa and pool owner’s nightmare. A salt chlorinator cell not working causes the water to become murky and dirty with time and most sane people wouldn’t touch it with a ten foot pole. More often than not, the problem is with the salt cell and not the entire chlorinator system itself.
Do you need a salt chlorine generator for Hayward pool?
Just like any other salt chlorine generator, the Aqua Rite may need a quick ‘tune up’ from time to time. Using information provided by Hayward Pool, we have created the following troubleshooting guide to help pool owners understand the diagnostic codes and quickly restore their Hayward Aqua Rite salt chlorination system. Important Tips!
How does desired output regulate chlorine in aquarite?
Here is the reply I received from Hayward support: When you set percentage to 50, and your pump run time is 12 hours, 90 minutes are one complete cycle. Then you have 90 minutes off, then cell switches polarity at 90 minutes on. When set to 25 percent, you are now at 45 minutes per cycle on a 12 hour pump run time.
