Why is my spa water not turning on?
The spa isn’t heating, or the water is a lot cooler than it used to be, but everything else seems operational. The water got very hot but then everything just shut down…now the spa won’t turn on, although power seems to be getting to it.
What should I do if my spa jets are not working?
Open this valve and there should be the sound of hissing air: keep open until water starts to come out, then close the valve. Force water directly into your spa’s jets with a garden hose, holding the hose directly but gently up against each jet for 20-30 seconds.
What to do if your hot tub is not working?
If it is 120 volts of household power, simply unplug it and then plug it back in after a couple of minutes. If both red and green lights are blinking, this could indicate low water flow. Resetting the spa by turning off the power, waiting and turning it back on is likely to resolve the issue.
What’s the reset button on an old spa?
Older spas used mechanical Temperature and Hi-Limit switches. This type of Hi-Limit can usually be reset by pushing in its reset button, a red or black button located on the heater or equipment pack (see your spa manufacturer’s instruction manual for exact location on your spa).
The spa isn’t heating, or the water is a lot cooler than it used to be, but everything else seems operational. The water got very hot but then everything just shut down…now the spa won’t turn on, although power seems to be getting to it.
What to do if your hot tub pressure switch is defective?
To check to see if the pressure switch is defective or miscalibrated, please do the following: Power down the circuit board. Unplug the pressure switch cable from the circuit board, thus revealing two pins. Power up the system. As soon as the low/filter pump turns on, jump the two pressure switch pins on the board with alligator clips.
Open this valve and there should be the sound of hissing air: keep open until water starts to come out, then close the valve. Force water directly into your spa’s jets with a garden hose, holding the hose directly but gently up against each jet for 20-30 seconds.
When to turn off the heater in a spa?
The Hi-Limit shuts off the heater or spa equipment when it detects a water temperature of 109° – 116°. The Hi-Limit on most newer spas can be reset by turning off the spa’s main power supply, and allowing the water to cool to below 100°.
What happens if you overtighten the nut on a spa heater?
Be careful not to overtighten the nut, as it will break or damage the piping. The spa isn’t heating, or the water is a lot cooler than it used to be, but everything else seems operational. Your spa’s water passes through the filter before it moves on to the heater.
