Why is my spa topide control panel not working?
But there are some ways to reduce the risk… read on. Bottom line is – it could be a bad spaside control panel, or it could be a bad spa control board, or a bad cable that runs between the control panel and the control board. Or it could be fuse on the circuit board or the transformer, not sending the correct power to the topside panel.
What to do if your spa control is not working?
If only a part is not working, look for error messages or blinking lights. As a first step, reset your breaker. If the problem persists, turn the breaker off and disconnect the panel to examine the circuit board.
What to do if your hot tub topide is not working?
If any of these symptoms are present, perform the following: Turn the power off and unplug the panel from the circuit board. If you have a intermittent fault then it maybe moisture at the PCB connection, dry it out, this may easily sort the problem. Repair of electronic spa sides is usually accomplished by replacement.
Is it better to replace a spa control panel?
You will be better off just replacing your complete spa control. The hot tub control panel is like a timer that keeps the spa’s temperature constant. It turns off the spa when you forget to and troubleshoots problems. Thus, it is very important to have a spa control system in good working condition.
But there are some ways to reduce the risk… read on. Bottom line is – it could be a bad spaside control panel, or it could be a bad spa control board, or a bad cable that runs between the control panel and the control board. Or it could be fuse on the circuit board or the transformer, not sending the correct power to the topside panel.
If only a part is not working, look for error messages or blinking lights. As a first step, reset your breaker. If the problem persists, turn the breaker off and disconnect the panel to examine the circuit board.
What to do if your hot tub control panel is not working?
As a first step, reset your breaker. If the problem persists, turn the breaker off and disconnect the panel to examine the circuit board. Turn the power on and check if the hot tub heats up or starts to filter. The surest way to check if a control panel works is to use one you know is working and connect it to the circuit board.
Why is my spa pump not responding to my buttons?
Derek it sounds like you may have a bad remote panel. Try disconnecting the remote panel from the sensor loom inside the skirt panel. Then try your main control panel button again. If it still does’nt work you may have a bad main control panel, bad connection at the PWA or a bad PWA.
