Why is my spa pump not responding to my buttons?
Derek it sounds like you may have a bad remote panel. Try disconnecting the remote panel from the sensor loom inside the skirt panel. Then try your main control panel button again. If it still does’nt work you may have a bad main control panel, bad connection at the PWA or a bad PWA.
Why does my hot tub control panel keep blinking?
If there is any condensation, dry it off. A blinking red light on the control panel may indicate it needs to be reset. For most models, you will need to turn off the power to the spa for a minute or two and then turn it back on again. Turn on the lower amp breaker first if you have a hot tub powered by 240 volts.
What to do if your hot tub pump goes bad?
The most important first step is to never turn on the power when your hot tub is empty. If the pumps engage severe damage can happen instantly, damaging your pump beyond repair. Other tips for pump preservation include: Fill the spa by putting the hose through the filter canister.
When do I need to run a spa pump?
Sometimes the topside controls indicate that you need to run pumps to purge air after the tub is full and in use. This priming should take no more than two minutes, by which time water should flow (not surge) from all of the jets (assuming the jets are clean ).
Derek it sounds like you may have a bad remote panel. Try disconnecting the remote panel from the sensor loom inside the skirt panel. Then try your main control panel button again. If it still does’nt work you may have a bad main control panel, bad connection at the PWA or a bad PWA.
Why is my spa topide control panel not working?
But there are some ways to reduce the risk… read on. Bottom line is – it could be a bad spaside control panel, or it could be a bad spa control board, or a bad cable that runs between the control panel and the control board. Or it could be fuse on the circuit board or the transformer, not sending the correct power to the topside panel.
If there is any condensation, dry it off. A blinking red light on the control panel may indicate it needs to be reset. For most models, you will need to turn off the power to the spa for a minute or two and then turn it back on again. Turn on the lower amp breaker first if you have a hot tub powered by 240 volts.
Why is my hot tub not running when I turn it on?
When the spa is refilled, some of that air may become trapped and act as a plug that keeps water from moving through the hot tub’s piping. If you turn on your spa, hear the pumps running, but see no water flowing from the jets, the most likely culprit is an airlock. Turn the spa off immediately to prevent damage to the heater and the pumps.
