Why is my soft tub not heating up?
Low flow in your spa or hot tub is most commonly associated with a dirty spa filter. If your spa heater won’t heat, remove and clean the filter(s) rule out a pressure or flow rate problem. Low water level, a clogged pump impeller, closed valves, clogged pipes or blocked spa drain covers can also cause flow issues.
Are there any problems with the softub hot tub?
Softubs are portable hot tubs designed for rest and relaxation. While using a Softub, some problems may arise including the main control panel not working and water leaks.
What to do if Power Light on softub is not working?
Press both the top button (the “reset” button) and the bottom button (the “test” button). Check the control panel again to see if the lights are working properly. Push the reset button on the Softub’s main control panel if the power light is blinking. If the power light continues to blink, unplug the Softub and plug it back in.
What happens if my jetted tub is not working?
If you access the plumbing system to try and fix this problem, you may void your jetted tub’s warranty. If the jets in your tub are not working properly (or are not working at all), you may have a secondary issue on top of this primary problem.
What happens when you turn off the Jets on a softub?
After the cycle has elapsed, the jets will continue to operate to heat the tub to the temperature you have set it to before returning to standby. Pressing the jets button again will turn off the jets and return the tub to standby immediately. Always keep the water level at least 2 inches above the top jet.
Softubs are portable hot tubs designed for rest and relaxation. While using a Softub, some problems may arise including the main control panel not working and water leaks.
Why are there no lights on my softub?
If there are no lights on the Softub’s control panel, check the ground fault circuit interrupter (GFCI) socket that the Softub is plugged into. The socket should have three prongs and two buttons on it.
What should the water temp be in a softub tub?
A: Softubs have a water temperature variance of 60-104 degrees, all simply controlled by using the up and down arrows on the digital control panel of the connecting motor pack unit. Running off any standard wall outlet to conserve energy, a Softub requires around 48 hours to heat the tub water upon filling and re-filling.
What do I do if my softub wont turn on?
Turn the air control valve on and off several times. If you cannot seem to shut off the air jets, you will need to toggle the air control valve to resolve the problem and shut the air valve. Press the “Jets” button on the control panel to turn on the jets.
