Why is my power jack not working?
For your electric jack, there are only three possible explanations for your jack not working with a charged battery. Either power is not getting to your motor, your motor is bad, or your ground connection isn’t working properly. If the motor works with that ground wire, then your motor is good and your ground is bad.
How do I add oil to my hydraulic camper Jack?
- Turn the release valve on the Hijacker camper jack clockwise to close it.
- Stand on the leg pad and pull the jack up to extend it fully.
- Turn the reservoir bolt counterclockwise with a wrench to remove it.
- Fill the reservoir with hydraulic oil.
- Reinsert the bolt and O-ring into the reservoir hole.
How do you retract Jack on Atwood levelegs?
Manually extend slightly, then retract that jack by holding down the EXT key and pressing the two keys on each side of the lights, then RET plus the same two keys.
How to troubleshoot an Atwood levelegs electric motor?
Unplug the wire to the motor on the troublesome jack, (there’s a connector a foot or so from the motor — it has a retaining clip that has to be pried up before pulling it apart) If this works and you can find a place that rebuilds electric motors, you could probably remove the offending jack and take it in for cleaning.
Why are the leveling jacks on my RV not working?
We’ve had a handful of members write in wondering what to do when the leveling jacks on their RV’s slide room, fifth wheel or tow trailer aren’t working properly. For most of these cases, their hydraulic system has either taken on a disturbing growling noise upon descension of the leveling jacks or they simply won’t retract back into the rig.
Can a camper have more than one electric Jack?
COMBINATION PROBLEM – If a camper has more than one jack that doesn’t run, it is possible to have more than one problem. There may be a button short in the remote control as well as a stuck relay in the receiver. In such a case, send both units in for testing and repair.
Manually extend slightly, then retract that jack by holding down the EXT key and pressing the two keys on each side of the lights, then RET plus the same two keys.
Unplug the wire to the motor on the troublesome jack, (there’s a connector a foot or so from the motor — it has a retaining clip that has to be pried up before pulling it apart) If this works and you can find a place that rebuilds electric motors, you could probably remove the offending jack and take it in for cleaning.
What should I do if my leveling jacks are not working?
Silicones and cleaning agents such as Dawn dish soap can worsen the corrosion and render your system irreparable. So what you should do is spray the system well with WD-40 and then wipe clean.
Why are the jacks on my RV not working?
One particular user who emailed in about this issue said they had cleaned and oil their hydraulic system, but the growling problem still persisted. Growling typically means there’s corrosion somewhere in your hydraulic system, likely in the shafts, and each manufacturer has its own recommendations for troubleshooting this issue.
