Why is my pool filter housing leaking?
A steady or high-pressure stream of water will likely indicate a bad gasket or o-ring. If the leak is coming from either of the pipes that lead into or out of the filter, the union seal or o-ring can be changed relatively easily.
Why does my pool pump keep blowing circuit breakers?
Be sure that nothing is jamming the pumps impeller and also make sure the pump has not been sitting in a puddle of water. Sometimes when pool pumps sit in a puddle of water for a while especially after a hard rain, they can get soaked and this will cause the circuit breaker to blow.
What to do if your pool pump is blowing?
Pool Pump Is Blowing The Circuit Breaker. If your pool pump is blowing the circuit breaker then chances are there is something really wrong with the pumps motor. The best thing to do is to bring it down to an electric motor repair shop or you can replace the motor with a new one and reuse the wet end of the pump.
What to do if your pool pump does not have an O-ring?
If your pump drain plug does not use an o-ring, make sure to use Teflon tape on the threads, and tighten with pliers to make sure the tapered plug is fully inserted.
Can a pool pump leak air through the drain plug?
These pumps can leak air from the front drain plug, if missing the o-ring. In fact, any pump can leak air through the drain plug if they are loose, or if Teflon tape is not used on the threads. If these five tests didn’t show you where the pump is drawing in air, here’s a little tip you can try.
Pool Pump Is Blowing The Circuit Breaker. If your pool pump is blowing the circuit breaker then chances are there is something really wrong with the pumps motor. The best thing to do is to bring it down to an electric motor repair shop or you can replace the motor with a new one and reuse the wet end of the pump.
Be sure that nothing is jamming the pumps impeller and also make sure the pump has not been sitting in a puddle of water. Sometimes when pool pumps sit in a puddle of water for a while especially after a hard rain, they can get soaked and this will cause the circuit breaker to blow.
What causes a leak under a pool pump?
In most cases, a leak underneath a pool pump is caused by a pressure-side leak. This is easily combated by inspecting the impeller housing o-ring, shaft seal and replacing any worn, cracked o-rings or seals.
Why is my pool pump not primed properly?
If not on properly, the pump will suck in air and the pump will not be able to prime. If that does not solve the problem you’ll want to check where the pipe enters the pump, the valve stem on any of the suction valves, the plumbing on the suction side of the pump (before the impeller), o-rings and gaskets.
