Why is my Pentair salt cell blinking?
From what you are explaining it sounds like you have the Pentair intelliChlor salt cell? If they are flashing red and green – you have too much salt and need to add water to your pool to dilute the salt. If the flow light is red, that means the water flow is too low to operate properly.
How do I reset my Pentair salt cell?
Press and hold the “More” button for 3 seconds to enter system status mode. All the lights will scroll across the panel, and then go dark. Only the “Power”, “Cell”, “Life”, and “Low” lights will be lit.
Why does my intellichlor salt level light keep flashing?
Depress the More and Less button together to deactivate Boost mode. If the green light is flashing in the Salt level area this indicates your salt level is high. If the green light is flashing in the Status area this indicates you should inspect the blades of the salt cell for debris and or calcium buildup.
Why does my intellichlor flash red and green?
Easytouch is powering the cell. No separate power box. And thanks for the link to the manual. That one is a different manual than the one I posted originally, but same issue. There is no troubleshooting code for “Salt level – green and red flashing”. But, obviously by the youtube video – it shows that behavior!
Is the Red flow light on on intellichlor?
I have a new intellichlor cell (installed 2 months ago) flashing red/green salt lights. the Red flow light is on. Thing is, the salt level reported by screenlogic and tested at the pool store is good (3350), and the flow is fine (see waterfall on video).
When does the check salt and inspect cell flash?
The ‘Check Salt’ & ‘Inspect Cell’ LEDs will flash when the cell reports the salt level is between 2400 – 2700ppm. In this condition chlorine is still being produced. The ‘Check Salt’ & ‘Inspect Cell’ LEDs will be ON when the cell reports the salt level is 2300ppm or less.
Depress the More and Less button together to deactivate Boost mode. If the green light is flashing in the Salt level area this indicates your salt level is high. If the green light is flashing in the Status area this indicates you should inspect the blades of the salt cell for debris and or calcium buildup.
Easytouch is powering the cell. No separate power box. And thanks for the link to the manual. That one is a different manual than the one I posted originally, but same issue. There is no troubleshooting code for “Salt level – green and red flashing”. But, obviously by the youtube video – it shows that behavior!
I have a new intellichlor cell (installed 2 months ago) flashing red/green salt lights. the Red flow light is on. Thing is, the salt level reported by screenlogic and tested at the pool store is good (3350), and the flow is fine (see waterfall on video).
Why is the intellichlor salt not producing chlorine?
IntelliChlor SCG will be producing chlorine at reduced efficiency. It is highly recommended to add salt. no chlorine production) due to a cold water condition. The goes above 52° F (11° C). Cell: Shows the status of the IntelliChlor SCG. inspected. The blades may have calcium buildup. The IntelliChlor SCG is not producing chlorine.
