Why is my Pentair easytouch remote not working?
Look at the receiver plate switch positions if your remote is able to control some functions of the Control Center, but not all. The circuits switches may be set incorrectly. The receiver plate is the mounted device that looks like a small circuit board, which receives remote control signals and translates them to the LX Control Center.
Where are the S1 switches on Pentair easytouch 8?
Flip all 10 of the the “S1” switches (located on the right side of the receiver) to “ON” using the sharp thin object on the receiver. Turn your remote control over and flip all 10 of its switches to “ON” as well. Your remote will now control all of the receiver functions.
Why does my Pentair pool remote say no Comm?
99% of the time now the remote will just say “No Comm”. While saying “No Comm” it’ll periodically cycle with “sync”. If I keep hitting the power button, eventually after a couple of minutes I’ll achieve sync and give me the normal display with the pool temp and time (which will be correct).
What does the plate on a Pentair easytouch look like?
The receiver plate is the mounted device that looks like a small circuit board, which receives remote control signals and translates them to the LX Control Center. Use a small tipped object (such as an unfolded paper clip) to move the switches of the receiver.
Are there any problems with the Pentair easytouch remote?
I have a Pentair EasyTouch system with an 8 channel wireless remote. For almost 3 years now the remote has worked great. Never had any troubles with it. Now for the last 6 months or so, I’m having serious connection troubles. 99% of the time now the remote will just say “No Comm”.
99% of the time now the remote will just say “No Comm”. While saying “No Comm” it’ll periodically cycle with “sync”. If I keep hitting the power button, eventually after a couple of minutes I’ll achieve sync and give me the normal display with the pool temp and time (which will be correct).
Why is my Pentair pool pump not working?
The base station operates normally, still controlling my pump and other circuits and running my schedule normally. The trouble is limited to the remote. I’ve called Pentair tech support who have been really helpful, but they say it must be an RF interference issue.
What to do if your Pentair easytouch 8 cord is damaged?
If the cord is damaged, replace it with a new one. Turn the remote control over and slide the battery chamber cover off with your fingers. Remove the battery to reset the connection and then slide the battery (3-volt lithium battery) back under the retainer clip.
Where can I get a rebate for a Pentair pool?
Blank rebate form is available above and warranty card is available below if you did not receive at purchase. Complete and submit the online rebate form. *These TradeGrade products must be purchased from a brick-and-mortar retailer, pool builder, or pool service professional in order to qualify for rebate.
