Why is my PDA in the error state?
What is the status of the LED’s on the front of the detector are when it is in the error state. If there is a flashing status then it is likely there is a problem with the charge amp PCB or the personality board. If the LED’s are green and steady after the failure then the detector may be resetting itself due to a power supply problem.
Why does my PDA have a flashing status?
If there is a flashing status then it is likely there is a problem with the charge amp PCB or the personality board. If the LED’s are green and steady after the failure then the detector may be resetting itself due to a power supply problem. It is unlikely to be firmware related and will probably require a service visit to rectify.
Is there a PDA error on empower 2?
PDA Error– Need Help! <p>We have an Acquity UPLC system with 4-column manager, PDA, and FLR (currently FLR is not in use), on Empower 2. I am getting this PDA error repeatedly.
Why does my PDA say time stamp is XXP?
The PDA needed reboot and after that, it starts working well, but the same error happens again during an injection or baseline monitoring. When this happens, the Empower Message Center shows “<strong>Dsp Time Stamp Qualification (xxx)</strong>” Warning.
Why is my Jandy Aqualink PDA not working?
The control panel is 99% lit up and frozen, with the exception of the pool mode light which is not on. The buttons … read more I have a jandy power center PCB 8124a. It will not power the i have a jandy power center PCB 8124a. It will not power the filter pump module … read more Jandy PDA handheld 1.38 is stick in “waiting” mode. I attem
Is the Jandy PDA 1.38 stuck in waiting mode?
Jandy PDA handheld 1.38 is stick in “waiting” mode. I attempted to change the channel and put the jbox in learn mode, but the i never got the next … read more My jandy PDA model 8265 is stuck opn waiting. I’ve tried My jandy PDA model 8265 is stuck opn waiting. I’ve tried changing the RF Channel but no response from the Jbox … read more
What to do if your water wont turn on?
Call your supply company and ask if they’ve turned the water off in your area. If you have a hard time turning your main valve, it might be stuck in a closed or partially open position. Your water will struggle to move past the valve’s restricted opening, losing pressure in the process.
What should I do if my water pump is not working?
Wiggle your pump pulley with your hand. If you notice damage or movement, replace the water pump. Rotate the pulley by hand. It should turn freely but not feel loose or rough; otherwise, replace the pump. On vehicles where the radiator fan attaches to the water pump assembly]
