Why is my hot tub says dry?
Newer hot tubs have a digital display for error codes that can assist with troubleshooting. A message such as “dr” or “dry” or “heater dry” is a warning that there’s no water in the heater tube, says Niagara Hot Tubs. If the water is low, add water to the proper level and try restarting the pump and heater.
What to do if your master spa pump is not working?
While cleaning your filter make sure there is no debris in your hot tub that will get sucked down into your pump. Run a hot tub temporarily with filters out of the hot tub and see if the problem continues.
How often does a Master Spa hot tub filter?
Your hot tub is only scheduled for filter 2 times a day for 2 hours. This may cause your water temp to not be at what you have it set at. The hot tub is in Sleep mode. While in Sleep mode your hot tub will filter 2 times a day for 2 hours a piece. Your hot tub does NOT heat during this time in this mode. The hot tub is in Standby mode.
What does it mean when your Master Spa says dry?
A substantial difference between the temperature sensors was detected. This could indicate a flow problem. For the error messages of HFL, LF, Dr, or DRY. This means that there is a flow issue through your heater. Try and clean your filters.
How to operate hot tub touch screen master spas?
In this episode our Master Spas TV Host, Maddiy, reviews some of the icons and their meaning that can be found on Master Spas touchscreens. The touchscreen control panel is featured on the following Master Spas products Twilight Series Hot Tubs, Michael Phelps Legend Series Hot Tubs, Michael Phelps Signature Swim Spas and most H2X Swim Spas.
How can I tell which jets are running in my Master Spa?
Next, depending on how many pumps you have on your custom Master Spas hot tub, it will show which jets are running on which pump. For example. If you have massage jets running with therapy pumps and the standard circulation jets you might have a button that says: Jets 1, Jets 2, and Jets 3.
How do I Turn Off the massage jets in my hot tub?
If you have massage jets running with therapy pumps and the standard circulation jets you might have a button that says: Jets 1, Jets 2, and Jets 3. To toggle the pumps on and off, simply press the jets you would like turned off. That will switch off the therapy pump you indicated.
While cleaning your filter make sure there is no debris in your hot tub that will get sucked down into your pump. Run a hot tub temporarily with filters out of the hot tub and see if the problem continues.
What to do if your spa has more than one jet pump?
If your spa is equipped with a second jet pump, repeat the priming process for Pump 2 by pressing the “Jets 2” button once to turn on low speed and then a second time to turn Pump 2 on high. If your spa has a 3rd pump, press the “Jets 3” button to prime the third jet pump.
