Why is my hot tub saying ICE?
When filling* your hot tub in cold conditions a warning message ‘IC’ or ‘ICE’ may appear. This is to inform you that the water temperature is below 7.2°C (45°F) and open to the risk of freezing.
What should I do if my hot tub pump is not working?
In this case, the spa pump should be located, and the union nut located between the spa’s plumbing and the motor should be loosened in order to release trapped air. Once all of the air leaks out, water will trickle out. When the stream of water becomes a steady flow the nut should be re-tightened, and the jets can be turned back on.
What to do if your hot tub is not in summer logic?
Also check to see that your spa is not in Summer Logic (spa water reaches 2 DEGREES above the set temperature). If your spa is in Summer Logic, cool the water off by opening the cover and or adding some cold water to the spa. If neither of these are the case you could have a bad Flow Switch or a bad connection to the Flow Switch.
Why does my hot tub have no water movement?
If your Topside is displaying a Solid FLO message you will have no water movement in the spa. Inspect your Flow Switch for hair or debris wrapped around the paddle. Also check to see that your spa is not in Summer Logic (spa water reaches 2 DEGREES above the set temperature).
Why is my Spa 2 speed pump not working?
II have a 2002 Optima spa. Several months ago the button on the top-side control panel for the 2 speed pump (#1) stopped working. There’s a second, smaller control panel on the opposite side of the tub which also will not work. But when the preset filter cycles occur the pump will come on and the icon comes on on the display.
What happens if you leave a hot tub pump on?
Don’t leave pumps and heaters on for more than 2-3 seconds if the hot tub is empty. Most cracking damage from any expansion caused by freezing ice happens to the heater body, the filter body, the cylinder that holds the filter cartridge, or the pump. Pipes rarely have a clean break. Rather, they have thin cracks that may eventually shatter.
What happens to the pipes in a frozen hot tub?
Most cracking damage from any expansion caused by freezing ice happens to the heater body, the filter body, the cylinder that holds the filter cartridge, or the pump. Pipes rarely have a clean break. Rather, they have thin cracks that may eventually shatter. Filling the tub is a good way to see where the leaks are originating from.
How can I Reset my hot tub pump?
First, the high-limit switch should be located. It will most often be a red button located on the spa pack or the pump. This button should be pressed and will click into place. From this point, the hot tub pump has successfully been reset, and the hot tub can be turned back on.
Can a hot tub freeze during a power outage?
Water this hot can often keep its heat for 2-3 days during a power outage. Unheated water combined with low outside temperatures can freeze in only an hour of not circulating. Once frozen (even if the power returns) the spa won’t be able to circulate water and cannot heat itself. Cover up!
