Why is my Hot Springs hot tub flashing?
When the power indicator is FLASHING RED, this means that the heater high limit has tripped. This means that the tub could be above its temperature limit or that the filters are clogged. The red flashing lights usually means that you’ll need to call for service.
Why does my hot spring spa have a flashing green light?
If this happened directly after a drain and refill the most likely cause is an air lock (air trapped in the circulation system) filling through the grey standpipe can often avoid this problem but not always. I will cut and paste the following since it still points to all the possible problems that can causing a flashing green ready light
When to use the spa and hot tub light?
The low speed pump or circ. pump will operate continuously until the temperature rises above 45° F. OH = Over heat. The spa is at a temperature above 108° . Do not use spa when temperature is flashing or the OH message is displayed.
When to use Spa when temperature is flashing?
Do not use spa when temperature is flashing or the OH message is displayed. HLoH = Hi Limit Over Heat. Hi limit sensor is disconnected or shorted or the spa temperature is above 112° F. SEoP = Sensor open or disconnected. Heater disabled but the spa is operational. SESH = Sensor short, nonfunctional.
What does it mean when your hot tub light is blinking?
Blue Logo “Power” indicator blinking = Heater high-limit thermostat tripped. • Disconnect power for at least thirty seconds to reset heater high limit. If it will not reset, check for clogged filters. If tripping continues, call for service. Sn1 = Nonfunctional high temperature sensor.
What does it mean when your hot spring spa has red flashing lights?
The red flashing lights usually means that you’ll need to call for service. Lastly, if the power indicator is OFF, that means that no power is being supplied to your tub and you need to call for service right away. We hope this quick and easy guide to the light indicators on your spa is helpful!
Do not use spa when temperature is flashing or the OH message is displayed. HLoH = Hi Limit Over Heat. Hi limit sensor is disconnected or shorted or the spa temperature is above 112° F. SEoP = Sensor open or disconnected. Heater disabled but the spa is operational. SESH = Sensor short, nonfunctional.
Why does my hot spring have a blinking light?
Low flow – This can be caused by a plugged filter or by a failing circulation pump – Best test is to turn the power off and remove filters completely, turn tub back on and see if the blinking light comes back. If it does not, replace circulation pump filter (the one with the gray cap).
What does the status indicator on a hot spring spa mean?
This is called the “status indicator”. This light will either be green, yellow, or red. A GREEN light indicates that everything is good to go. The spa is not detecting any issues that you should be concerned about. A YELLOW light means that the spa requires attention.
