Why is my Hayward perflex de filter EC50 leaking?

Added the 5lbs of DE powder. Everything is good. Noticed a little drip where the motor connects to the filter, but no problem, just tighten up. Went inside for a while, came back out and water was leaking from where the lid caps on to the filter body. I checked the clamp and the sleeve nut. Tightened as tight as it would go, coils touching.

What are the symptoms of a Hayward pool filter?

Common symptoms seen with DE pool filters include: A Hayward Perflex DE filter has a part known as a bump shaft that allows you to manually shake off the DE particles from the parts inside. It is often found on filters that do not have a backwash feature.

How much D.E powder do I need to backwash my ec40 filter?

But the measurement for filter media (D.E.powder) is done in LBS or pounds. The EC30 will take 3lbs of D.E., the EC40 will use 4 lbs of DE., the EC50 & 65A should use around 5.5 lbs of D.E every time you backwash it.

What to do if your Hayward d.e.filter is stuck?

If the handle on the bottom of your Hayward D.E. filter tank is stuck, or broken and you cannot open the valve, well your not alone. This is a common problem. What you can do is remove the old handle and then take a pair of channel lock pliers or a small pipe wrench and open the valve by turning the valve stem sticking out from the valve.

What should I do if my pool filter is not working?

The only regular maintenance is to clean out the filter periodically when it has captured so much debris that water isn’t flowing properly. If you have a cartridge filter, you can take out the cartridge and clean it. If you have a DE filter, you can remove the filter, wash it off, and then replace the DE.

What makes a Hayward perflex pool filter different?

The Perflex pool filter by Hayward is a popular DE filter for small to medium sized pools. Installed on thousands of pools nationwide, they are distinct in design, and operate differently from other DE pool filter types. The main difference is the grid assembly, called a “ Filter Nest ” on the Perflex filter.

How to replace the bump handle on a Hayward ec65?

In order to replace the bump handle on the Hayward EC65 or other sizes is to first remove the bump handle grip. This is the grip that is at the end of the handle itself. If you have a yellow tank EC filter you will just pull off the grip, as it is probably a runner one.

What kind of bolt pattern does Hayward EC filter have?

Depending on how old your Hayward EC filter is will determine if you have a bellyband or a bolt pattern. The older Yellow Perflex tanks had a bolt pattern with many bolts. The newer Gray Perflex tanks now have a bellyband with just one bolt you will have to remove or tighten.

Do you need replacement parts for Hayward perflex?

Hayward makes many replacement parts for the EC Perflex filter line so there is no need to worry about finding or buying replacement parts. You will only need a few common tools to be able to take apart and fully rebuild or repair your EC30, EC40, EC50 or EC65 swimming pool filter.

What are the names of the perflex pool filters?

Hayward Swimming Pool Products makes a D.E. pool filter called the Perflex EC-Series Swimming Pool Filter. They make a few different sizes of this Perflex pool filter. The different names of the EC filters are the EC-30, The EC-40, The EC-50 and The EC-65, which is the largest model of the EC-SERIES line.

What should I add to my Hayward pool filter?

After backwashing, new DE must be added to the filter. Add the entire amount of DE the filter recommends. If you see DE returning to the pool, vacuum it to waste, after it settles. The next time you backwash and recoat, decrease the amount by 1 pound. This will avoid DE going back into the pool.