Why is MY FAULT light on on my water heater?
All you have to do is pump in some gas for the heater. And once the gas meter is full your water heater will work again. Additionally, your fault light will turn off on its own. If there is a spark near the igniter and the tank is full then your problem lies in the circuit board. And quite often this is the main culprit.
How to troubleshoot a gas water heater problem?
Replace and repair the parts of the water heater with caution. Make sure that the pilot control valve of the heater is turned off before you start repairing. Secure the water supply to the heater and drain the heater. Always refer to the user manual for troubleshooting tips, it can solve the problem more often than not.
Why does my Propane Water Heater get lukewarm?
If the dip tubes fail, the hot and cold water will mix, and your water will be lukewarm. If you experience other problems, such as: the pilot won’t light or stay lit, your water is too hot, or the main burner won’t stay lit, or you have slow recovery time, the above causes apply, as well.
Why is the DSi FAULT light on in my RV?
You exclaim that you certainly turned the water heater on. And yet the water did not warm up. So, you decide to pay a visit to the water heater panel inside your RV. That’s when you notice that the DSI fault light is on. Yes, that’s the light that tells you that there is something wrong with the water heater.
All you have to do is pump in some gas for the heater. And once the gas meter is full your water heater will work again. Additionally, your fault light will turn off on its own. If there is a spark near the igniter and the tank is full then your problem lies in the circuit board. And quite often this is the main culprit.
Why does my LP water heater make a clicking sound?
You can check the LP system by simply turning on stovetop inside of the unit. When the unit turns on will you will hear a clicking sound. If the unit clicks but there is no flame, it might mean there is a clog or blockage in the system.
What is the DSi FAULT light on Atwood RV water heater?
I spoke with my contact at Dometic (who took on the Atwood water heaters) and they said that the DSI fault light on the switch for your Atwood RV Water Heater # AT94022 (GC10A-4E) will only come on for two reasons.
You exclaim that you certainly turned the water heater on. And yet the water did not warm up. So, you decide to pay a visit to the water heater panel inside your RV. That’s when you notice that the DSI fault light is on. Yes, that’s the light that tells you that there is something wrong with the water heater.
