Why is my Dometic toilet flush not working?
Failure of the flush was the final straw after also experiencing continual leaks from the blade, the handle jamming in the open position, useless tiny wheels, a design that meant needing three hands to empty it whilst pressing the air release valve etc etc etc. Even when the flush was working it was pathetic by Thetford standards.
Why does my RV toilet not hold water?
Trust us, you don’t want to be unfamiliar with your toilet when you’re somewhere up a mountain in negative temperatures and discover that the bowl won’t hold water… You’ll typically only have to worry about one key part of the RV toilet, and that’s the seal that separates the basin from the drain and retains water.
When do you turn off the water on a new toilet?
This can happen any time the water is on and may happen after a new installation, a few days later or even months and years after installation. Turn off water and flush the toilet. Reach into the tank with your right hand and lift up the float cup and grip the gray shaft and hold it in that position (see photo below).
How can I fix the bottom of my RV toilet?
With your toilet upside down, install the new closet flange seal lip side out on the bottom of your toilet (you’ll want gloves on when dealing with the bottom of your toilet) Place the toilet overtop of the black tank hole (plastic has been removed of course) lining the bolts up with the holes on the base of the toilet.
Is there a problem with the Dometic toilet?
Editor’s note: Several RVers have commented about this problem; all have reported that Dometic was quick to respond by sending out a new 310 model toilet. Previous article Missing or damaged roof vent?
How does a toilet fail in an RV?
There are two ways for an RV toilet to fail. First, water won’t enter the bowl when the foot pedal is depressed, so waste is not washed away. Second, water enters the bowl, but does not exit.
How to replace a series 300 RV toilet?
The Series 300 has been replaced by Series 310 at your service center. If you choose to replace it yourself, shut off the water to your RV. Disconnect the water line at the rear of the commode. Unbolt the commode from the floor and lift it straight up.
This can happen any time the water is on and may happen after a new installation, a few days later or even months and years after installation. Turn off water and flush the toilet. Reach into the tank with your right hand and lift up the float cup and grip the gray shaft and hold it in that position (see photo below).
How does a Dometic vh12 vacuum flush toilet work?
System vacuum is monitored by a vacuum switch that is located on the outside of the VHT. When the switch senses a drop in vacuum in the system, it automatically signals the pump to energize and bring the vacuum back to operating level. This process is normally completed in about one minute.
How tall does a vacuum flush toilet need to be?
Can be installed up to 20 feet (6.1 meters) from the toilet using 1-1/2 (38mm) sanitation hose. VacuFlush systems use a small amount of water (one pint to one quart) and the vacuum that is generated by the vacuum pump to flush. Each toilet must be connected to a pressurised water system.
Why is Dometic toilet not working in Coachman Caravans?
Our comedy dometic flush has also failed, if this is dometics idea of improving the caravan toilet maybe they should organise a work experience day at Thetford! On the subject of the fuse,why does it tell you there is one in the coachman handbook but not say where or how to take apart the toilet to get to it,ok,rant over
Is the Dometic 310 toilet a good toilet?
It wasn’t bad, but it wasn’t great either. Our original Thetford Aqua-Magic Style II toilet. On the plus side, it didn’t use much water, it was reasonably comfortable and the jets of water when you flushed were fairly powerful, keeping the bowl clean.
Is the Dometic toilet lid easy to clean?
Since one of my main criteria was a toilet that’s easy to clean, the rimless design was a plus point, and the slow-closing seat and lid sealed the deal! For the past 6 months or more, we had been working with Dometic, consulting for them on their Customer Tech Council to provide feedback and guidance on their products – existing and upcoming.
When to replace flush ball in Dometic RV toilet?
Replace the flush ball assembly in your Dometic RV toilet. Flush ball opens when foot pedal is pressed to flush waste into your RV’s holding tank. Shaft, spring cartridge, and hardware included. Videos are provided as a guide only.
It wasn’t bad, but it wasn’t great either. Our original Thetford Aqua-Magic Style II toilet. On the plus side, it didn’t use much water, it was reasonably comfortable and the jets of water when you flushed were fairly powerful, keeping the bowl clean.
Since one of my main criteria was a toilet that’s easy to clean, the rimless design was a plus point, and the slow-closing seat and lid sealed the deal! For the past 6 months or more, we had been working with Dometic, consulting for them on their Customer Tech Council to provide feedback and guidance on their products – existing and upcoming.
Why is the bottom of my Dometic toilet black?
First, the valve at the bottom often failed to seal shut. This led to the water draining out and bad odors rising back up from the black tank – ew! Even with a thorough cleaning, it would seal for a few days and then go back to draining. Second, the seat and lid were cheap, flimsy plastic.
What should I do if my toilet won’t flush?
To provide more specific troubleshooting information on your toilet seal, we need the make and model of the toilet. However both the Dometic and Thetford versions offer a replacement gasket for the flapper or ball type toilet. Thetford Commode lets water in and ball valve seals well to hold water. Ball valve wil not open to flush.
Why is the hand valve on my RV toilet not working?
It could have calcium or lime buildup. Otherwise you will need to take the plastic cover off the foot mechanism and the lower plastic shroud to gain access to the valve assembly. There you can see if it’s just sticking or the spring has broken or come loose. I have a Thetford toilet with the hand valve lever to rinse and flush.
Failure of the flush was the final straw after also experiencing continual leaks from the blade, the handle jamming in the open position, useless tiny wheels, a design that meant needing three hands to empty it whilst pressing the air release valve etc etc etc. Even when the flush was working it was pathetic by Thetford standards.
Our comedy dometic flush has also failed, if this is dometics idea of improving the caravan toilet maybe they should organise a work experience day at Thetford! On the subject of the fuse,why does it tell you there is one in the coachman handbook but not say where or how to take apart the toilet to get to it,ok,rant over
To provide more specific troubleshooting information on your toilet seal, we need the make and model of the toilet. However both the Dometic and Thetford versions offer a replacement gasket for the flapper or ball type toilet. Thetford Commode lets water in and ball valve seals well to hold water. Ball valve wil not open to flush.
It could have calcium or lime buildup. Otherwise you will need to take the plastic cover off the foot mechanism and the lower plastic shroud to gain access to the valve assembly. There you can see if it’s just sticking or the spring has broken or come loose. I have a Thetford toilet with the hand valve lever to rinse and flush.
Is there a problem with my Dometic refrigerator?
We have had problems with our Dometic RM5310 refrigerator for some time. The symptoms are it lights easily on gas but won’t stay lit. We eventually found that if after driving on 12 volts we left it for half an hour or so to cool down it would eventually light but it could easily take half a dozen or more attempts first.
How to troubleshoot a Dometic EA 3120 refrigerator?
Dometic EA 3120 refrigerator troubleshooting 1 Immediately turn the refrigerator off. 2 Open windows and door to air out the coach and evacuate. 3 Contact a Dometic dealer or Service Center. 4 Do not use the refrigerator until it has been repaired.
How to fix a dislocated Dometic refrigerator bulb?
Below is a table of Dometic refrigerator troubleshooting system. • Dislocated thermistor bracket. Clip thermistor bracket to last fin on right side of cooling flange and center vertically on fin. • Dislocated thermistor bulb.
How to troubleshoot the back of a Dometic refrigerator?
Okay, now let’s move on to trouble shooting techniques. Check all the circuit breakers and fuses. Check the outlet on the back of the refrigerator. Use a multi meter to check for power voltage. If the voltage checks out okay and all lights work, then check the electric heating element. Beware this has dangerous voltage…. Check the flame.
Why is the toilet not Flushing in my RV?
There are two main reasons why your RV toilet is not flushing. First, water isn’t entering the bowl when the foot pedal is depressed, so waste is not washed away. Second, the water enters the bowl but does not exit. Both issues are symptomatic of larger problems and rectifying them can be time consuming and unpleasant.
Where is the baffle on a Dometic refrigerator?
The baffle is inside the flue. Use an air compressor to blow air into the flue. Continue to use the air compressor to remove dust and debris that has built up around the compartment. I hope some of these basic Dometic refrigerator parts and troubleshooting tips can get you back on the road quickly. What do you think?
Is the cooling unit on a Dometic refrigerator gravity operated?
Below is a useful diagram of the gas absorption cooling unit on your Dometic refrigerator: The first thing to know is that the cooling units on every Dometic gas absorption refrigerator are gravity operated and MUST be level in order to run properly.
