Why is my clever SPA saying HL?
An HL error usually means there is a blockage, preventing water from circulating around the pump & heating system.
Which is the correct error code for spa?
(Displays when first powered up after refill). Spa operating in Standard Mode. Spa operating in Economy Mode. Safety Suction, Spa is shut down. Spa operating in Standard-in-Economy Mode. Overheat Protection (Heater is deactivated, pumps low speed is activated). Spa water is more than 20° F cooler than the temperature set point.
Why does my Vita spa not turn on?
Overheating condition where a water temperature sensor has detected water temperatures of 110°F (43.3°C). Spa functioning is then disabled until temps fall below 108°F (42.2°C).Could indicate a pump operating at low speed for an extended time, constant filtering due to a programming error or a faulty pump. DO NOT GET INTO THE WATER!
What does hi limit mean on a hot tub?
Hi limit sensor is disconnected or shorted or the spa temperature is above 112° F. SEoP = Sensor open or disconnected. Heater disabled but the spa is operational. SESH = Sensor short, nonfunctional. Heater disabled but the spa is operational. PSoC = Pressure switch open with circulating pump. PSoL = Pressure switch open with low pump.
What should the temperature be in a spa heater?
Temperature in the spa heater housing is below 40° F. Status of the heater element is unknown. The low speed pump or circ pump will operate continuously until the temperature rises above 45° F. Over heat. The spa is at a temperature above 108° . Do not use spa when temperature is flashing or the OH message is displayed.
(Displays when first powered up after refill). Spa operating in Standard Mode. Spa operating in Economy Mode. Safety Suction, Spa is shut down. Spa operating in Standard-in-Economy Mode. Overheat Protection (Heater is deactivated, pumps low speed is activated). Spa water is more than 20° F cooler than the temperature set point.
Overheating condition where a water temperature sensor has detected water temperatures of 110°F (43.3°C). Spa functioning is then disabled until temps fall below 108°F (42.2°C).Could indicate a pump operating at low speed for an extended time, constant filtering due to a programming error or a faulty pump. DO NOT GET INTO THE WATER!
Temperature in the spa heater housing is below 40° F. Status of the heater element is unknown. The low speed pump or circ pump will operate continuously until the temperature rises above 45° F. Over heat. The spa is at a temperature above 108° . Do not use spa when temperature is flashing or the OH message is displayed.
Hi limit sensor is disconnected or shorted or the spa temperature is above 112° F. SEoP = Sensor open or disconnected. Heater disabled but the spa is operational. SESH = Sensor short, nonfunctional. Heater disabled but the spa is operational. PSoC = Pressure switch open with circulating pump. PSoL = Pressure switch open with low pump.
