Why is my chlorinator cell saying low volts?

Sorry to hear of your problems. The “Low Volts” error message indicates that the chlorinator cell (SWG) voltage is too low. It would be interesting to see the cell amps and volts. To enter the Diagnostic Menu, press the “Menu” button on the local (or remote) display repeatedly until the display shows “Diagnostic Menu”.

What does the chlorinator off no flow message mean?

Within minutes, the “Chlorinator Off No-Flow” message went away, and the only messages remain are as follows: “Chlorinator Off – Low Temperature”, and “Check System – Low Salt”. I have the following Temperature readings: Pool Temp: 57 Degrees F, Cell Temp Sensor: 58 Degrees F, Water Sensor: 57 Degrees F, Air Sensor: 57 Degrees F.

What are the messages on chorinator off no flow?

I also connected TurboCell connector to Main Board. Within minutes, the “Chlorinator Off No-Flow” message went away, and the only messages remain are as follows: “Chlorinator Off – Low Temperature”, and “Check System – Low Salt”.

When to turn off the chlorinator in a pool?

Check System Light On: Cell Power Error Message Verify the system is configured for correct model cell. (Page 18). If the incorrect cell is chosen, the system will inaccurately interpret the salt level in the pool and the system may turn the chlorinator off. Maximum Current (Amps) before shutdown Page 10 3.

When does a chlorinator shut down a salt cell?

Unlike low salt the system does not shut the chlorinator down when a specific salt level is reached. Instead the unit will suspend chlorination when the cell’s amperage draw exceeds a certain value.

How to turn off super chlorinate in ProLogic flow control?

To display the settings, press the Menu key until Settings Menu appears. Then press the > until Super Chlorinate appears . Use the (+) or (-) button to toggle between super chlorinate On or Off depending on preference. Then press the (>) one time to display chlorinator % options. Step 2