Why is my ceiling light socket not working?
By far the most common problem is a loose wire connection at the switch itself, which is subject to constant on-off usage. Less commonly, a light bulb socket may go bad. If so, you will need to replace the socket.
What would cause a ceiling fan light to not work?
Why ceiling fan lights may fail to work The primary reason why ceiling fan lights may stop working is due to loose wire connections. A ceiling fan with light generates heat, while in operation, which causes expansion and contraction of electrical wires. Eventually, wires may loosen and cause the lights to stop working.
Why are there no lights in living room ceiling?
Simple answer. The National Electric Code did not require ceiling lights in living rooms so many builders opted to save the few dollars by not putting lights and their associated wiring in to any room not required to have lights.
When do house batteries need to be charged?
With a meter you should read a voltage at the positive terminals. They will read very low if no charging voltage is present. The house batteries (as well as chassis batteries) should charge when the engine is running, if not then you should find a fuse in a positive 12 volt feed between them and the alternator.
Why do my lights not come on when not connected to shore power?
With 12 volts present when the charger is running when on shore power, one would suspect there is a wire routing issue, as you should get 12 volts from both the charger and or the batteries if things are connected properly. I have a feeling that you do not have 110 volts from the inverter output when you are not connected to shore power.
Why do my house batteries not charge when I run the engine?
They will read very low if no charging voltage is present. The house batteries (as well as chassis batteries) should charge when the engine is running, if not then you should find a fuse in a positive 12 volt feed between them and the alternator.
Why are the lights not coming on in my RV?
THAT MEANS YOUR BATTERY ISOLATOR (COULD BE DIODE-BASED OR SOLENOID BASED) IS NOT WORKING. BOTH BATTERY BANKS SHOULD BE CHARGED BY THE ALTERNATOR. Plugged in not running the Batteries are at 12.58.
