Why does spa drain in spa mode?
Although it’s hard to tell, it looks like the return valve is slightly open to the pool which would cause the spa to slowly drain in spa mode. It looks like all of your suction is coming from spa. Move skimmer valve so water from main drain is getting through and maybe pinch down suction from spa also.
How to troubleshoot an issue with your spa?
To troubleshoot an issue with your spa, locate your specific problem in the chart below to help determine a probable cause, and then apply the right solution. Do you need to call a professional technician? Do you need to call a professional technician? Adjust the total alkalinity and pH.
Are there any problems with my hot tub?
Hot Spring ® spa systems are reliable and will last a long time with regular maintenance, but issues do sometimes arise. To help set you on the right track toward fixing minor hot tub problems with jets, pumps, heaters, electrical systems, controls, and water quality, we’ve created an easy-to-follow chart below.
What should I do if my pool pump does not turn on?
If your pump does turn on, but loses power, it could be overheating. Try running the pump during the night to avoid overheating. If this does not work, check the bottom vents of the motor to make sure there is nothing inhibiting the fan. If the problem persists, you’ll have to replace the pool motor or pool pump.
Why does my pool pump keep sucking air?
Pool pumps are supposed to be completely airtight: this is what keeps them primed and sucking water properly. So, when they start sucking air, that’s a problem. Usually, it’s because of a bad thread sealant, crack in the pump, an air leak in the suction line, a plumbing issues on the suction side of the pump, or a leaky valve stem.
How do I get the water back into the spa?
I have 2 questions: How do I get the water back into the spa (on my … read more The water flows from my spa to pool to pump/filter and back to spa. Lately, when the pump is turned off, the water drains out from spa down to the same level as the pool.
Why does the spa drain when the pump shuts off?
A raised body of water that actually shares the same system as the main pool that is lower than the spa naturally wants to drain into the main body of water below it because of gravity. The check valve prevents back water flow from going into the pool.
Is there a leak in my spa pump?
There is no actual leak. Essentially, it is just moving. Depending on the model of your check valve, you may be able to replace the main part of it, or you may actually have to replace the entire valve. You may also have smaller check valves that are actually in your return lines that bring water back to the spa.
When did I put the Jandy system on my spa?
I have a Jandy System put in Dec 2002 where I can remote control switches to a built-in hot tub…. pool/tub combination. The hot tub runs off into the … read more I turned on the spa and heater and the spa drained? Now I turned on the spa and heater and the spa drained? Now what? … read more
