Why does pool heater say spark?
the fact that you’re getting the spark, means that all of the heater safety switches are working and closing the circuit, it just doesn’t sound like the gas is getting to the spark, so should be an inexpensive fix for sure. Experience: Servicing pools and all brands of spas for over 28 years.
What is a spk code?
SPK means “Spark”. They are status codes, not fault codes. It basically means that the heater is turning on the heat mode and spark should appear shortly after the CFH code appears.
What does spk mean on pool heater?
SPK means that the heaters safeties are all closed. You have to change the set point above the water temperature in the pool or spa so the heater will light the pilot and prove that it is lit.
What should I do if I find a fault in my Raypak heater?
Power found at either PV or MV at the incorrect time. 1. Turn power OFF and disconnect Ignition Wire and Gas Valve wires from board. 2. Power ON and watch for spark at module. 3. If no spark, turn power OFF, and replace board. 4. If spark is observed, turn off power and reconnect wires. The unit should fire.
Why do you need a Raypak pool heater?
Your Raypak pool heater keeps your pool comfortable throughout the seasons. So naturally, it gets a lot of use during that time. While pool heat pumps are built to provide countless hours of heat, they still need maintenance to stay at peak performance.
What does BD1 mean on a Raypak heater?
The panic really doesn’t set in until you realize error code BD1 means absolutely nothing to you. Error codes are both curses and blessings. Although an error message is never really a good thing, at least it’s an indication of what the problem is. Just imagine how much easier it would be to diagnose diseases if humans came with error codes.)
Where does the Spark Go in a pool heater?
With thermostat turned up, the call for heat should be sending a small, visible electric spark, jumping the gap from the end of the rubber coated wire, to the connector.
