Why does my water heater thermostat keep going out?
This often happens if the element’s metal casing cracks and the element’s live wires are exposed to water. If there’s a short in your heating element, the power will continue flowing in the element even after your thermostat turns off its power.
What happens when pilot goes out on Kenmore water heater?
The thermocouple will usually shutoff the pilot light after about 20 seconds and you should hear a click. This is a safety device that turns the gas off when the pilot goes out. Most Kenmore units have an electronic or fused thermocouple that must be purchased from Sears. In some cases they may not have them in stock.
Is there an error code on my Kenmore water heater?
These error code explanations can help you diagnose a problem with your Kenmore gas water heater. For repair how-to help, visit the PartsDirect repair help section, which includes repair help for water heaters, major appliances, lawn and garden equipment, garage door openers, vacuum cleaners and more.
Where can I buy a Kenmore water heater?
Most Kenmore units have an electronic or fused thermocouple that must be purchased from Sears. In some cases they may not have them in stock. When you replace the thermocouple on a Kenmore water heater you should also replace the combustion chamber gaskets in order to provide an adequate seal. The gaskets can also be purchased from Kenmore.
Is there a way to turn up the heat on a gas water heater?
Gas water heaters are easy—they feature a single knob that controls the amount of heat being directed to the unit. Turning this knob to the left (counterclockwise) will crank up the temperature, making the water hotter. Turning it to the right (clockwise) will cool it down.
What causes a Kenmore water heater to shut down?
The gas control has sensed a problem with the flammable vapor sensor. Replace the vapor sensor. If replacing the vapor sensor does not correct the fault, replace the control. Control has sensed an error in the temperature sensing circuit and has shut down the water heater.
How to troubleshoot a gas hot water heater?
Gas hot water heater troubleshooting usually leads you to the thermocouple. Go to the article ‘Gas Water Heater Thermocouple Issues’ for information on this common repair. The other less common problem would be the gas valve. A bad gas valve will not allow any gas to go to the burner or pilot light.
These error code explanations can help you diagnose a problem with your Kenmore gas water heater. For repair how-to help, visit the PartsDirect repair help section, which includes repair help for water heaters, major appliances, lawn and garden equipment, garage door openers, vacuum cleaners and more.
How is the temperature of the hot water heater controlled?
The temperature is controlled by the gas valve. The valve assembly will have a dial that will allow for temperature adjustment and will also have a probe that monitors the water temperature. If adjusting the dial does not achieve the desired water temperature, then the valve assembly must be replaced.
