Why does my slide not retract or extend?
The slide would not retract or extend. We had some emergency fixes to bring the slide in so we could drive. Apparently, there are special considerations and tools that are necessary to align the full length slide. Has anyone had a problem with a slide topper hanging up when extending their slide?
What should I do if my slideout is not aligned?
Extend and retract the slide a few times and check for proper room flange sealing. If the room is not properly aligned, repeat steps 1 thru 6. *Depending on the size of your slide, you may need help moving the room by hand.
What causes an RV slide out to not work?
A faulty motor or gearbox could be the problem if your RV slide-out gear system is motor-driven. In such cases, if the motor is faulty or breaks down, then the mechanism will not work. If the motor-driven gearbox system is faulty, for whatever reason, your RV slide-out will not work. Your RV slide may experience resistance as it moves in and out.
What kind of wiring diagram does Damon daybreak use?
Damon Daybreak Wiring Diagram Keys Can Access Control Car Auto10 Caubro Warmi Fr Diagram Suzuki Df6 Wiring Full Version Hd Quality Ritualdiagrams Politopendays It Ef 3443 Damon Challenger Motorhome Wiring Diagram Diagram 1998 Coachmen Mirada Rv Electrical Wiring Full Version Hd Quality Ritualdiagrams Politopendays It
Can a Damon intruder slideout be torqued?
This sets the coach “true” so the slides are not “torqued”, which can cause binding and damage. I own a 2003 Damon Intruder. My owner`s manual states that you should NOT operate the slides until the motor home is level to avoid binding and other damage to the slides.
What’s the best way to retract slideouts?
Every seminar I have attended says to always operate the slides at road level, which means to put them out before leveling the coach and bring them in after raising the jacks. This sets the coach “true” so the slides are not “torqued”, which can cause binding and damage.
Why does my slide not retract after new motor?
After the new motor was installed, the slide still would not retract. The “square rods” connected to the motor were detached to assure the new motor was functioning. We found that power to the motor existed only when the “out” part of the slide’s in/out button was pushed. There was no power to the motor when the “in” side of the button was pushed.
Is there a replacement motor for a disco slideout?
All disco owners are in sympathy with you and would all say the replacement motor is worth the $. On the Disco, the driver side slide fits flush to the floor when extended. The three men are getting it over the ramp to retract. There is a replacement motor with higher torque available.
