Why does my pool heater say check flow?
It means that there is debris or dirt that causes it to clog. Another reason is that the water level is low and blocks the basket due to dirt. As you read on, you will learn that a clogged filter and impeller results in poor water flow.
What does Flo mean on built right pool heater?
The code FLO means “Low or No Water Flow Detected”. It is a self-protection mechanism that prevents the heater from operating if there isn’t enough water moving through the heat exchanger.
When to call for service on a Jandy heat pump?
If the water leak continues, after the heat pump is shut off for at least one hour, call for service. Low or restricted water flow through the heat pump. The external bypass valve is in the wrong position, or the water flow switch has malfunctioned. The water flow switch opens creating a fault and the heat pump shuts off.
How to troubleshoot a Jandy ae2000 heat pump?
Jandy Ae2000 Heat Pump Troubleshooting Diagnostic Condition Description LOW H2O FLOW Low or restricted water flow through the The external bypass valve is in the wron The LCD screen will display LOW H2O FLOW LOW COIL TEMPERATURE When the evaporator coil temperature is
How can I tell if my Jandy pool heater is bad?
The ignition sequence begins and when fan starts watch the sight glass on the igniter until it turns red indicating that the start sequence is ready to light the heater. CAREFULLY wiggle the connectors on the sensors until you hear a relay click in the gas valve and the heater lights off. This identifies the bad connection.
How does the water sensor work on a Jandy heat pump?
The water sensor will read this temperature and the control will shut off the chiller. The LCD display will show LOW H2O on the top line and TEMPERATURE on the bottom line for the duration of the fault condition. This feature also remains active when the control calls for chill through a remote thermostat.
The ignition sequence begins and when fan starts watch the sight glass on the igniter until it turns red indicating that the start sequence is ready to light the heater. CAREFULLY wiggle the connectors on the sensors until you hear a relay click in the gas valve and the heater lights off. This identifies the bad connection.
How to check IGN steps on Jandy JXI pool?
Carefully check to be sure no wires came loose and reconnect if they did. Reset breaker and allow the RS 12 to power up. Start the heater at it’s control panel. The ignition sequence begins and when fan starts watch the sight glass on the igniter until it turns red indicating that the start sequence is ready to light the heater.
How do you start a Jandy pool heater?
Start the heater at it’s control panel. The ignition sequence begins and when fan starts watch the sight glass on the igniter until it turns red indicating that the start sequence is ready to light the heater. CAREFULLY wiggle the connectors on the sensors until you hear a relay click in the gas valve and the heater lights off.
When to call for service on a Jandy pool heat pump?
If this does not correct the problem, call for service. When the head pressure builds too high, the high pressure switch will open causing the heat pump to shut off immediately. The control will sense this fault condition and shut off the compressor until the switch re-closes.
