Why does my pool filter keep stopping?
There are several reasons why your pump may randomly shut off—a behavior known as “pump tripping.” Most commonly, your pump may be operating at the wrong voltage, overheating, or simply failing to compete with your neighborhood’s electrical needs.
How often does pool filter need to be cleaned?
A commonly asked question amongst our customers is, “when should we clean our pool’s filter cartridge?” Typically, we recommend that your cartridges inside your filter be cleaned every 3 months for longevity of your cartridges, as well as for better pool filtration and water flow.
Why does my pool pump keep sucking air?
Pool pumps are supposed to be completely airtight: this is what keeps them primed and sucking water properly. So, when they start sucking air, that’s a problem. Usually, it’s because of a bad thread sealant, crack in the pump, an air leak in the suction line, a plumbing issues on the suction side of the pump, or a leaky valve stem.
Why is my pool pump not primed properly?
If not on properly, the pump will suck in air and the pump will not be able to prime. If that does not solve the problem you’ll want to check where the pipe enters the pump, the valve stem on any of the suction valves, the plumbing on the suction side of the pump (before the impeller), o-rings and gaskets.
What to do if your pool pump does not fill?
If your pump basket does not fill with water, you’ll have to prime the pump. The good new is it’s pretty straight forward, just follow the steps below: Disconnect any power to the pump and move the diverter valve so that the main drain side is turned to off.
Are there any problems with a pool filter?
For a piece of equipment that is not electrical, digital, or highly complex, a pool filter can still cause a great deal of pool owner stress. You might be surprised how many questions we field regarding what is essentially a big tank that water passes through.
What should you do if your pool filter is low?
If the pressure spikes, immediately shut off the pump. Low pressure in your filter is much less dangerous than high pressure, but it means your filter isn’t doing its job. Low pressure will (almost) always be caused by a problem at or before the pump.
Why does my pool pump pressure keep going up?
See Pool School for suggestions. Other causes of a spike in filter pressure are a broken check valve or improper valve setting. Higher than the normal filter pressure usually indicates a dirty filter which just requires cleaning the filter.
What should I do if my pool pump is not primed?
If water is not flowing freely in the strainer box, return to step one and repeat. Switch the diverter valve back to half way between the skimmer and main drain. If the pump is still not primed, check the impeller for debris and filter pressure for anything 10psi above the clean reading for your pool filter.
How often should a sand filter be turned on in a pool?
Having too small of a pool filter pump motor will cause the pump to work harder and it won’t be able to filter the dirt out of the swimming pool. Normally a residential pool filter pump should turn over the water at the most every 8 – 10 hours. Commercial pools may do it a little faster.
