Why does my pool breaker keep tripping?
It may be because of four reasons: Your circuit breaker is short-circuiting from the water or corrosion collected by the pool pump. Debris from the rain goes into the housing, making the motor overwork. It can also be due to moisture from certain weather conditions as well.
When to trip a circuit breaker in a spa?
Use this procedure if the spa continually trips the breaker during operation. This is intended for use by spa service technicians only. Before beginning this procedure, ensure the GFCI circuit breaker is wired properly. We recommend using a Square D brand GFCI. Test for pump 1 or circulation pump and heater
What to do if the main pump is off in Sundance spa?
If debris is present, remove debris, install switch and test system. If condition still exist, replace switch.) if switch measures infinite (no continuity) with pump off, switch is OK, Turn on Main pump and measure across switch terminals for continuity. If continuity is measured, switch is OK.
What is the error code on the Sundance Spa hot tub?
Sn1 Error Code: Heater is deactivated. High-limit sensor located in the heater drywell is nonfunctional. Sn3: Heater is deactivated. Main temperature sensor located in filter bucket is nonfunctional. 6. ILOC Error Code ILOC Error Code: Hot Tub is deactivated.
How can I tell if my Sundance spa filter is defective?
The only way to test this is to make sure there is no loose debris in the spa, then pull the filter out and see if the flow error goes away, if it does, it is the filter. 2. Defective Circ Pump or Flow Switch: Need to check for Circ Pump operation.
Why is my Sundance Spa having trouble shooting?
1. Dirty Filter: even when you have cleaned the filter, the filter may be impacted and be time for a new filter. The only way to test this is to make sure there is no loose debris in the spa, then pull the filter out and see if the flow error goes away, if it does, it is the filter.
What to do if your hot tub breaker tripping?
First: Turn the Breaker off and test with a meter to be sure you have no power coming to the spa. Second: On most Flo Thru Heaters, you will find 2) Heater Terminals, with a 3/8″ Nut holding a copper strap or wire attached to the terminal from the Circuit Board.
What kind of circulation pump does Sundance Spa use?
Note: This test only works on 850 Series with Circulation Pump prior to 2001: Try turning the #1 pump which is 2 speed.
Why does the GFCI breaker trip on my spa?
When a component is turning on and off due to circuit interruptions, the GFCI breaker may trip.Fixing loose connectors is pretty easy. Inside your spa pack, you may need to use a screwdriver to tighten the screws keeping wires in place.
