Why does my hot tub keep tripping the GFCI?
If your GFCI constantly trips, one of the following issues might be the culprit: Your hot tub heater may be corroded or otherwise damaged. Problems with the heating elements are among the most common causes of GFCI issues.
What are the features of the LSX 800 hot tub?
Live life better with the LSX 800, a premium hot tub inspired by the best. The spacious model offers premium features, beautiful styling, and outstanding performance. Up to six adults can enjoy the ultimate in hydrotherapy thanks to the 70 Orbit jets, lounge seating, and Master Blaster Foot Therapy.
Is there a way to troubleshoot a Master Spa?
The spas have a low energy consumption and are generally low maintenance. As with any spa, however, you will likely run into some issues. Try troubleshooting them on your own before you spend the money on a repairman. Check to see if the control panel displays any messages if nothing on the spa operates.
Where is the GFCI on a Master Spa?
(*The GFCI should be located in a weatherproof box close to the spa, but no closer than 5 ft.) If the spa does not respond, contact your dealer for service. Press the “Jets” button on your control panel. Check that all the slice valves are open.
What is the sp800 and SP1200 installation and service manual?
SP800 & SP1200 Installation & Service Manual The SP800 and SP1200, mid to high end range of spa pool control systems can be installed and configured in many ways for many different pool configurations.
Live life better with the LSX 800, a premium hot tub inspired by the best. The spacious model offers premium features, beautiful styling, and outstanding performance. Up to six adults can enjoy the ultimate in hydrotherapy thanks to the 70 Orbit jets, lounge seating, and Master Blaster Foot Therapy.
What should I do if my Master Spa wont reset?
One of the sensors detected 118°F at the heater. Remove spa cover and let the water cool down. After the water has cooled, push any button to reset. If the spa doesn’t reset there is an issue with sensors onPC board. Find replacement PC board
How often does a Master Spa hot tub filter?
Your hot tub is only scheduled for filter 2 times a day for 2 hours. This may cause your water temp to not be at what you have it set at. The hot tub is in Sleep mode. While in Sleep mode your hot tub will filter 2 times a day for 2 hours a piece. Your hot tub does NOT heat during this time in this mode. The hot tub is in Standby mode.
(*The GFCI should be located in a weatherproof box close to the spa, but no closer than 5 ft.) If the spa does not respond, contact your dealer for service. Press the “Jets” button on your control panel. Check that all the slice valves are open.
