Why does my hot tub have no water movement?
If your Topside is displaying a Solid FLO message you will have no water movement in the spa. Inspect your Flow Switch for hair or debris wrapped around the paddle. Also check to see that your spa is not in Summer Logic (spa water reaches 2 DEGREES above the set temperature).
What to do if your hot tub control panel is not working?
If your hot tub control panel still isn’t working properly or displaying properly then there are a number of things that you can try to see if you can get it working again. However, if your hot tub is still under warranty then you should consult your dealer rather than trying to fix the problem yourself.
Why does my hot tub have a Flo message?
The message can also be caused by soiled filters, plugged or bad Flow switches or a bad connection from the Flow switch to the PWA. In rare instances a bad PWA could cause a solid FLO message. If the pump checks out try and look at the filter, the circ line, the wiring to the Flow switch and the Flow switch.
What to do if your hot tub circulation pump is not working?
Disconnect the plumbing and turn it on very briefly to see if any funny noises are made. Depending on the location of the problem, a replacement of the bearings, motor, entire circulation pump will be required. Pro-Tip: Your spa circulation pump should run with as little noise as possible.
If your Topside is displaying a Solid FLO message you will have no water movement in the spa. Inspect your Flow Switch for hair or debris wrapped around the paddle. Also check to see that your spa is not in Summer Logic (spa water reaches 2 DEGREES above the set temperature).
What to do if your hot tub has a bad flow?
If your spa is in Summer Logic, cool the water off by opening the cover and or adding some cold water to the spa. If neither of these are the case you could have a bad Flow Switch or a bad connection to the Flow Switch. If all else fails contact our Service support team to book a spa diagnostic and repair of your spa.
The message can also be caused by soiled filters, plugged or bad Flow switches or a bad connection from the Flow switch to the PWA. In rare instances a bad PWA could cause a solid FLO message. If the pump checks out try and look at the filter, the circ line, the wiring to the Flow switch and the Flow switch.
Why is a hot tub control panel important?
A hot tub control panel acts as a timer, keeps the temperature constant, turns off the spa if you forget to, and helps troubleshoot problems with your spa. This is why it is important to keep the control panel in good working order.
