Why does my Hayward say no flow?
“No Flow” LED illuminated. The Hayward Aqua Rite has sensed a no flow condition and has stopped generating chlorine. Check that the flow switch is plugged into the connector on the bottom of the control unit and that the wire is not cut or damaged.
What does the chlorinator off no flow message mean?
Within minutes, the “Chlorinator Off No-Flow” message went away, and the only messages remain are as follows: “Chlorinator Off – Low Temperature”, and “Check System – Low Salt”. I have the following Temperature readings: Pool Temp: 57 Degrees F, Cell Temp Sensor: 58 Degrees F, Water Sensor: 57 Degrees F, Air Sensor: 57 Degrees F.
When do Goldline cells shut down in chorinator?
The other thing it is no longer happening, is that Pumping of Water and Filter are no longer stopping after 15-20 minutes of operation. The Goldline cells should not shut down until 50F so my suspicion is that the board may be bad. Have you checked the infamous solder joint?
What are the messages on chorinator off no flow?
I also connected TurboCell connector to Main Board. Within minutes, the “Chlorinator Off No-Flow” message went away, and the only messages remain are as follows: “Chlorinator Off – Low Temperature”, and “Check System – Low Salt”.
Are there any problems with the Goldline check system?
Hope this helps! Aloha! This problem sounds very common to the Goldline system in the sense of the check system / flow / incorrect salt and the most infamous no cell power issue. There is an issue in the goldline PCB board and the factory soldered circuits giving up on the circuit board.
Hope this helps! Aloha! This problem sounds very common to the Goldline system in the sense of the check system / flow / incorrect salt and the most infamous no cell power issue. There is an issue in the goldline PCB board and the factory soldered circuits giving up on the circuit board.
Is the chlorinator still off on my salt cell?
My salt cell is new and configured properly and all diagnostic issues check out OTHER than the fact my system still states the chlorinator is off and no flow. The pool is operating just fine and EVERYTHING else is in order.
What should I know about the Goldline salt system?
The thing to remember is once the Goldline senses a problem with the salt system it will continuously display incorrect salt readings and functions until the problem is resolved. Once resolved it should resume proper operation, and since it doesn’t cost anything, you don’t have to invest anything to troubleshoot.
How to diagnose a Hayward Aqua rite flow switch problem?
The NO FLOW LED stays ON when there is a flow switch problem. 1 Verify if your flow switch was installed correctly. 2 The arrow at the top of the hex nut points in the direction of the water flow. 3 Flow switches require a minimum flow fate of 11 gallons per minute to stay consistently closed 4 Check for damaged or cut wires
