Why does my dolphin pool cleaner do wheelies?
What causes automatic pool cleaners to flip or do wheelies? The water level in a pool is one of the most common causes for this problem. When the water level is too high, the water line is very close to the coping. So when the cleaner starts to climb the wall, it hits the coping and flips on to its back.
How do I get the dolphin pool cleaner out of my pool?
To remove the Dolphin Cleaner, pull the Pool Cleaner to the pool’s edge, grab the handle, turn the Cleaner 90 degrees, and pull the Cleaner up out of the water. Do not pull the Pool Cleaner up by its power cord.
Which is better dolphin Nautilus or dolphin DX3 pool cleaner?
The DX3 cleans the floor and walls as well as most other inground pool cleaners. Still, we think that the DX3 robotic pool cleaner is not really better than the much more popular Dolphin Nautilus Plus. It is also more expensive than the Nautilus pool cleaners ( read our Nautilus review ).
Why is my dolphin pool cleaner not working?
The light may be on in the control unit but it may not be putting power out from the plug area that the dolphin plugs into. As well as the motor in the dolphin head could be bad. Most often it is the control box. Ask Your Own Pool and Spa Question
Why is my dolphin not putting power out?
it could be. The light may be on in the control unit but it may not be putting power out from the plug area that the dolphin plugs into. As well as the motor in the dolphin head could be bad. Most often it is the control box. Ask Your Own Pool and Spa Question Customerreply replied 9 years ago Were can I find a new control box?
What’s the difference between a dolphin DX3 and a DX4?
Dolphin DX3 versus DX3S. The biggest difference between these models are the filter type. The DX3 has a filter bag while the DX3S has cartridge filters. The cartridge filters might be easier to clean than a bag, but it fills up more quickly with debris.
What to do if your dolphin is not picking up dirt?
Dolphin Troubleshooting Guide 04/2019 Page 3 5. My Dolphin is not picking up dirt/debris, or it’s escaping out the top of the unit: • Check your filters and the impeller to make sure they are clean. Remove any debris from the impeller area. • Check the intake opening on the bottom side of the cleaner for any obstructions.
Why does My dolphin want to float in my Pool?
• When a Dolphin wants to float it is usually due to trapped air in the cleaner or the pool’s chemicals are out of balance – either the pH or salinity. Refer to your owner’s manual for appropriate ranges.
Can a dolphin be used with an extension cord?
Dolphin is not designed to be used with an extension cord, surge protectors, or any other electrical component other than originally manufactured by Maytronics). • If your cleaner is still not operating properly, please take cleaner to your local Maytronics dealer.
Why is my pool not drawing enough water?
The presence of air in the lines is preventing the system from drawing water as it should. Possible reasons for this problem include the following: The water level in the pool is too low. Make sure the water is high enough to cover all the skimmers—if there is more than one—and all the return jets.
