Why does my Bullfrog spa shut down for 15 minutes?
Means there is a possibility of dry heater or an insufficient amount of water in the heater in order to start it. The spa system will shut down for 15 minutes. Press any of the buttons in order to reset heater start-up. See box for “Flow Related Checks” down below.
How to troubleshoot a bullfrog hot tub breaker?
Disconnect one component at a time from the control board and try restarting the spa. If the breaker trips, reconnect the component then try again by disconnecting a different component. Continue repeating this process until the breaker does not trip. Components include pumps, heaters, lights, stereos, ozone, etc.
What does spa mean on Bullfrog Water Heater?
All of the water devices are then activated. The pumps may cycle on and off in some cases, and the heater may function during Freeze Protection. This is not an error indication but an operational message. Means the spa system has detected that the water temp is 110°F (43.3°C) or more, thus disabling spa functions.
Where can I buy a new Bullfrog hot tub cover?
You can Order your new Bullfrog Replacement Hot tub cover here. There will be many messages and alerts that appear on the main screen during your ownership. Many of them may be displayed in sequence. You can often reset the spa unit by pressing the “jets” button.
What to do if your Bullfrog spa pump is not working?
The wet-end of the pump has a bleed valve—loosen this until all the air escapes and water starts to drip out, or loosen the union on the pump to let the air out until you see water. Do not attempt this while the spa pump is running. If you need help doing this or this does not resolve the problem, please contact your authorized Bullfrog Spa Dealer.
How to prevent airlocks in a bullfrog hot tub?
To prevent airlocks when filling your spa, be sure to open all valves in the JetPaks and all other jets in the spa before filling to allow as much air as possible to escape from the system during the filling process. Fill your spa through the filter by taking the filter cap off and put the hose directly in the filter.
Why is my Bullfrog hot tub making a burning noise?
If your spa pump is creating a burning smell or making excessive noise, the pump motor is defective. This can happen when running the pump during high ambient outside temperatures or due to excessive run times. Please contact your authorized Bullfrog Spas dealer for replacing the pump.
What should water temp be in Bullfrog hot tub?
Open the cover for several minutes, long enough to allow the water to cool down. Repeat a couple times weekly as necessary. For safety reasons, never leave your spa unattended with the cover open. If OHH is displayed on the control panel, this means that the thermometer has detected spa water temperature above 110 degrees F.
