Why does my Arctic Spa hot tub pump fail?
Typical hot tub pumps fail more often because they are internally cooled, allowing moist or dusty air to contaminate the interior components of the pump. The spa pump from Arctic Spas is completely sealed and externally cooled to prevent premature failure.
Where can I get a new hot tub pump?
Bring your old pump (any brand) to an Arctic Spas retail store and get a free estimate to repair or replace it. Spa pumps are usually compatible between different hot tub brands. Arctic Spas has the best pump available and it probably works in your hot tub even if it is not an Arctic.
When does Arctic spa Rev 1.1 come out?
Rev 1.1 Rev Date 24 Apr 2015 The Spas firmware is designed to detect most errors, and then the CPU will provide feedback for the user on the topside, mobile application and by flashing the lights on the spa. Temperature probe is disconnected from the base board
What should water temperature be on Arctic spa?
Over temperature. The water temperature of the spa is > 112oF (44.5oC) High limit. The temperature of the heater barrel is > 119oF (48oC) Flow Switch Open. The flow switch is reading no flow while pump 1 is running. Flow Switch Closed. The flow switch is reading flow while pump 1 is off.
Can a hot tub pump be repaired at Arctic Spas?
Each Arctic Spas dealer prides themselves on offering great service so if you need a hot tub part or accessory call or visit a dealer near you. Hot tub pump problems can usually be repaired: you probably don’t need a new pump! The two most common problems with hot tub pumps are the seals and the motor.
What to do if your spa pump is not working?
With over 25 years of experience, we’re equipped to help with any spa issues you have or to discuss a new spa. When your spa pump is making noises… This usually happens if you recently drained the spa. Open the lock nut until you hear air hissing, then tighten up again as water begins to leak.
What to do if your circ pump is not working?
Check that your power is on, the breaker or GFCI test button are not tripped, all valves are in the open position. Follow the circ pump plumbing, and look for any kinks in the hose.
Why is my Arctic spa not showing HPT?
Requested function has been disabled due to a suspected ground fault. When spa is powered up it performs a check to see if the hi-limit probe is attached to the heater barrel. While this is happening “tSt” will be displayed. If the heater probe test fails then HPt will be displayed.
