Why does my Aqua rite pool read zero?
First, and most importantly, in order for the Aqua Rite to check the salt level in the pool it has to be producing chlorine, however if the salt level is over 4000 ppm it will turn itself off and not make chlorine. So if you are trying to test the salt level you may get a zero reading because of the Catch 22.
Which is Hayward aquatrol is for me?
The HP model can be installed in either the vertical or horizontal position; though Hayward prefers the HP be installed horizontally. The package also includes the flow switch to protect the cell and detect proper waterflow.
How can I tell if my aquarite needs to be replaced?
To determine if you need to replace the cell, check the water temp on your Aquarite’s control panel diagnostic’s. If the water temperature reads 215 degrees F, the cell temperature sensor is shorted and the cell needs to be replaced.
What causes the Aqua Trol to stop working?
Filter pump switched off or filter pump time too short ( 8 hours for average size pool, more for large pools) Salt level too low (below 2500 ppm, Low Salt LED on) Very warm pools increase chlorine demand- increase Desired Level % or filter run time. Cold water (below 50F) causes Aqua Trol to stop generating (Generating LED flashing).
What should the salt level be on my Aqua Trol?
Check to make sure the cell installed is a T-Cell-5. The LCD display will read “HI”. Verify salt level is 2700-3400ppm and check with independent test to ensure accuracy. If salt level is above the range, partially drain pool and/or spa and refill with fresh water to achieve a salt level of 3200ppm.
How many gallons does an aqua Trol pump handle?
High Voltage Electrocution Hazard Page 1 The Aqua Trol incorporates a built in timer to control the pool pump, controls a T-cell-5, and is designed to handle the sanitization needs of above ground pools up to 18,000 gallons.
How to reset Aqua Trol diagnostics Manual Step by step?
Requires manual reset. To manually reset the Inspect Cell LED, press and hold the Diagnostics button until LED goes out (approximately 3 to 5 seconds). Step A
