Why does my 2002 Intrepid not start after a jump?

2002 intrepid would just click click click. jump it, it would fire right up. autozone alt/battery are good. took off all negative cables and cleaned them tighten them all backdown and the car fired right up.. In addition to the supplied answers it could also be a faulty crank position sensor.

Why is my hot tub not working properly?

As soon as moisture enters anything electrical the water starts to conduct electricity and cause problems. Obviously, if the components remain damp, they can also corrode which again will lead to big problems.

What causes a car to stop after a jump?

If the engine is cranking but not firing then check this. It will cause a car to run for sometime then slowly die as described. I would look at an electronic reason as to why the car is stopping. The car should start IMMEDIATELY when it is jumped and it should stay running.

Can a timing chain jump cause a problem?

Of the many things that can go wrong with and engine, the timing chain jumping can be one of the most frustrating problems to have. Depending on the motor, it can cause all sorts of problems. They require a lot of mechanical skill to replace.

When did I put the Jandy system on my spa?

I have a Jandy System put in Dec 2002 where I can remote control switches to a built-in hot tub…. pool/tub combination. The hot tub runs off into the … read more I turned on the spa and heater and the spa drained? Now I turned on the spa and heater and the spa drained? Now what? … read more

How do I get the water back into the spa?

I have 2 questions: How do I get the water back into the spa (on my … read more The water flows from my spa to pool to pump/filter and back to spa. Lately, when the pump is turned off, the water drains out from spa down to the same level as the pool.

Why is my spa draining when on Spa mode?

I drained the spa to put in fresh water. Water temp was about 54 degrees. On restart the spa went in to “watchdog” mode. How do I reset it? … read more