Why does Maax spas water pump auto reset?
Once water temperature is below 108°F (42.2°C), system auto resets.Could indicate a pump operating at low speed for an extended time, constant filtering due to a programming error or a faulty pump. DO NOT GET INTO THE WATER! Take off the heat shield cover to allow the water to cool down.
What to do if your Maax Spa is not working?
Take off the heat shield cover to allow the water to cool down. Make sure that the slice valves are open and reprogram the spa to make sure there are no overlapping time cycles. Open all jets. Contact the dealer or service organization if the problem continues.
What is the number of the Maax hot tub?
811 – The Maax Spas 811 hot tub is a family friendly hot tub with many seat levels including a deep sitting corner and a lounge. 781 – The Maax spas 781 hot tub is a hydrotherapy treat with a large capacity of seating levels including a lounge, coupled with a large amount of jets.
Why is the green logo on my hot tub blinking?
Green Logo “Ready” indicator blinking = Heater Temperature sensor problem. Blue Logo “Power” indicator blinking = Heater high-limit thermostat tripped. • Disconnect power for at least thirty seconds to reset heater high limit.
Take off the heat shield cover to allow the water to cool down. Make sure that the slice valves are open and reprogram the spa to make sure there are no overlapping time cycles. Open all jets. Contact the dealer or service organization if the problem continues.
Once water temperature is below 108°F (42.2°C), system auto resets.Could indicate a pump operating at low speed for an extended time, constant filtering due to a programming error or a faulty pump. DO NOT GET INTO THE WATER! Take off the heat shield cover to allow the water to cool down.
811 – The Maax Spas 811 hot tub is a family friendly hot tub with many seat levels including a deep sitting corner and a lounge. 781 – The Maax spas 781 hot tub is a hydrotherapy treat with a large capacity of seating levels including a lounge, coupled with a large amount of jets.
What does it mean when spa light is blinking?
SnA = Spa is shut down. Sensor plugged into jack A is not working. Snb = Spa is shut down. Sensor plugged into jack B is not working. SnS = Sensors out of balance. If alternating with temp, may be temporary condition. If display shows only this message (blinking) spa is shut down.
