Why does a salt Cell stop working?
Salt cells fail for a few different reasons, the main reason being lack of proper maintenance. It is very important to check the cell regularly for excessive buildup. Use a cleaning kit designed for salt cells to keep the plates clear of buildup. Another common cause of salt cell failure is improper water balance.
How long does a salt water chlorinator cell last?
about five years
This is all possible thanks to your pool’s salt chlorine generator cell. With proper care, a cell will last about five years.
What causes instant salt reading to be zero?
There are two cases where the instant salt reading will be zero. The first is if the cell is not currently active it will show an instant salt reading of zero. You appear to have done the correct things to check for that, turning up to 100% and insuring that the water is above 60 degrees should allow the cell to always be on.
How to troubleshoot problems with your salt cell?
Starting with the average salt reading. Turn the switch to ‘Off’, then back to ‘Auto’. Wait for the relay to click (about 5 to 10 seconds). Press the ‘Diagnostics’ button 5 times, this will bring up the instant salt reading.
When to add salt to a salt cell?
If value is not reading within 500ppm of independent test, then replace cell. If number is reading within 500ppm of the independent test and the ‘Inspect Cell’ LED is flashing, add salt until level is above 2700ppm. The ‘High Salt’ LED will be ON when the cell amperage is above the maximum limit.
What does no cell power on Hayward AquaLogic mean?
My diagnostic message began as “low temp” with my water at 80 degrees F, then after resetting many times by cycling the power my diagnostics said “Check Salt Level” and my true salt level was 3200PPM. So I suggest anyone whos cell will not click on check the K1 joint. Easy fix. You are the man, this was brilliant!
What to do if your salt cell is not working?
Below are a few tips on how to deal with salt cells that don’t work. 1. Replace or repair damaged units immediately when problems are identified. 2. Replace the entire unit every once in a while. More often than not, a well maintained and high quality system should offer decent service for up to 5 years.
There are two cases where the instant salt reading will be zero. The first is if the cell is not currently active it will show an instant salt reading of zero. You appear to have done the correct things to check for that, turning up to 100% and insuring that the water is above 60 degrees should allow the cell to always be on.
When does the check salt and inspect cell flash?
The ‘Check Salt’ & ‘Inspect Cell’ LEDs will flash when the cell reports the salt level is between 2400 – 2700ppm. In this condition chlorine is still being produced. The ‘Check Salt’ & ‘Inspect Cell’ LEDs will be ON when the cell reports the salt level is 2300ppm or less.
My diagnostic message began as “low temp” with my water at 80 degrees F, then after resetting many times by cycling the power my diagnostics said “Check Salt Level” and my true salt level was 3200PPM. So I suggest anyone whos cell will not click on check the K1 joint. Easy fix. You are the man, this was brilliant!
