Why do I keep getting FCS errors on my switch?
If not down to a physical problem, then these can be caused by duplex mismatches between switch and the end device. Try manually setting the speed/duplex at both ends.
Where is the source file in / FC?
Consider the following code sample, where the source file is located in C: est\compiler_option_FC.cpp: Without /FC, the compiler output looks similar to this diagnostic text: With /FC, the compiler output looks similar to this diagnostic text: C: est\compiler_option_FC.cpp (5): error C2143: syntax error: missing ‘;’ before ‘}’
Where do I find the FC option in Visual Studio?
The /FC option is implied by /ZI. For more information about /ZI, see /Z7, /Zi, /ZI (Debug information format). In Visual Studio 2017 and earlier versions, /FC outputs full paths in lower case. Starting in Visual Studio 2019, /FC uses the same casing as the file system for full paths. Open the project’s Property Pages dialog box.
When do you need / FC for diagnostics?
Without /FC, the compiler output looks similar to this diagnostic text: With /FC, the compiler output looks similar to this diagnostic text: C: est\compiler_option_FC.cpp (5): error C2143: syntax error: missing ‘;’ before ‘}’ /FC is also needed if you want to see the full path of a file name when using the __FILE__ macro.
How to set an errorlevel in fc File Compare?
Errorlevels. FC will set an ErrorLevel as follows: -1 Invalid syntax (e.g. only one file passed) 0 The files are identical. 1 The files are different. 2 Cannot find at least one of the files. For an invalid switch (with two passed files) an error message is printed but the errorlevel is not changed.
If not down to a physical problem, then these can be caused by duplex mismatches between switch and the end device. Try manually setting the speed/duplex at both ends.
Why is my Nexus FC Port brought down?
This document describes the reasons why a Fibre Channel (FC) port on a Multilayer Director Switch (MDS) or Nexus FC capable switch is brought down due to “Error disabled – bit error rate too high”. A detailed description of Error Disabled states can be found here: Step 1.
What causes the FC Port to be disabled?
Be aware of these 2 defects that disables the port/s when 15 bursts of bit errors occur within 5 hours instead of 5 minutes. It’s still a physical layer issue and needs to be addressed.
