Why do I keep getting error codes on my spa?
These error codes can be caused for several different reasons. The main reason is water flow through the spa control system, if water is not flowing at a rate to satisfy the pressure switch, it will result in one of the error codes above.
What does it mean when your Spa is overheating?
Print If your Spa is going over the maximum temperature limit of 104 Fahrenheit degrees or over the set temperature, is most likely because the Pump has been running for extended periods of time, which might be due to 2 main reasons: Extended Filtration Cycles settings.
What are the error codes on the Balboa spa?
Balboa Spa Side Error Codes pd Power supply, unit running on battery ba OH Sensors reading 112-118° F. OHH Overheat. Spa has shut down. One sensor OHS Overheat. Spa has shut down. One sensor
When to troubleshoot a SPA112 and a spa122?
This document explains some options to troubleshoot a SPA112 and a SPA122 when the phones connected to them fail to ring out. When the phone does not ring this means the call forwarding features on the phone are enabled. The user knows the call forwarding feature on the phone is enabled when there is a slow tone on the line.
What does the code OH mean on a hot tub?
OH : Overheat. Spa temp over 108°. HLoH : Hi Limit Over Heat. Hi limit sensor is disconnected, shorted, or spa temp is above 112° F. SEoP : Sensor open or disconnected. Heater disabled but spa operational. SESH : Sensor short, nonfunctional. Heater disabled but spa operational.
What to do if your spa has an error code?
If the problem stays SnA, then you have a bad PC board. Same with the error SnB. Find replacement PC board. Sensors are out of balance. If this alternating with the temp, it may just be a temporary condition. If the display shows only this message (blinking), the spa is shut down. Shut the spa off for 20 min to reset the power.
What does the Oh message on the spa mean?
The spa is at a temperature above 108° . Do not use spa when temperature is flashing or the OH message is displayed. HLoH = Hi Limit Over Heat. Hi limit sensor is disconnected or shorted or the spa temperature is above 112° F. SEoP = Sensor open or disconnected.
When does spa go into priming mode what does it mean?
Inadequate water detected in heater.. Inadequate water detected in heater. (Displays on third occurrence of “dr” message). Spa is shut down. When spa is first actuated, it will go into Priming Mode. Interlock failure – possible pump or ozone spike. Unknown water temperature. (Displays when first powered up after refill).
