Why do I have to keep bumping my pool filter?
When bumping/ backwashing doesn’t work: Sometimes just ‘dumping’ the old De isn’t enough to get you back to proper filter performance – this can be caused by algae (or some other fine debris clogging the DE), or neglect (you didn’t clean the filter soon enough), or the grids/ fingers getting clogged up.
What is bumping a pool filter?
What is Filter Bumping? First to describe bumping, a term unique to Diatomaceous Earth filters. Bumping will regenerate the D.E. currently in the tank and can extend time between backwashing cycles saving you money by reducing the amount of Diatomaceous Earth used throughout the season.
What happens if you put too much DE in pool filter?
Adding too much DE to your pool may cause multiple negative results. These ramifications include a clogged skimmer, turning the pool cloudy, reducing the circulatory pressure in the pool and putting too much work on your pump that may result in eventually breaking the pump.
How often should you bump a pool filter?
Once a year
Once a year, the filter should be taken apart and thoroughly cleaned. lters are unique because they cannot be backwashed. Once the filter pressure rises 8-10 PSI over clean starting pressure, it is time to bump the filter to regenerate the DE.
How does the bump handle on the Hayward perflex filter work?
This bump handle allows you to shake the D.E. from the pool filter fingers that are inside of the tank. The Hayward Perflex filter has man options that may seem confusing at first, but once you read and learn how to use this type of pool filter you will have no problem keeping your swimming pool clear and blue.
What are the numbers on the Hayward perflex ec65?
8 Washer Item Number: ECX1077 10 Screw Item Number: SPX1500N1 10a Washer Item Number: ECX1641125 12 O-Ring Item Number: ECX9611246PAK3
How do you back wash a Hayward perflex pool filter?
This is done using the swimming pool filter systems pump. You first have to bump the handle on top of the filter a few times and then open a valve to back wash the filter. See below for a full lesson on how to properly back wash your Hayward Perflex D.E. Pool Filter.
How do you bump a perflex d.e.filter?
Once you have shut the filter system down you will want to bump the handle up and about 10 times and then you will want to turn the filter back on again. What the bump does is loosen all of the D.E inside of the filter, turning it over and then once you turn the filter back on the D.E. re sticks to the filter fingers.
How to replace the bump handle on a Hayward ec65?
In order to replace the bump handle on the Hayward EC65 or other sizes is to first remove the bump handle grip. This is the grip that is at the end of the handle itself. If you have a yellow tank EC filter you will just pull off the grip, as it is probably a runner one.
How to replace a broken Hayward swimming pool filter?
Once you push over the tab you will pull the grip off of the bump handle and then you can slide it on to your replacement Hayward EC filter bump handle. Now that you have replaced the grip on the handle you will want to remove the cracked or broken handle from your Hayward Swimming Pool Filter.
What makes the Hayward perflex D.E filter so unique?
If you over tighten the gauge you cab crack the filter housing. What makes the Hayward EC-series filter so unique is the way it works with the “bump handle” or D.E. media regeneration handle. This handle is used to regenerate the D.E. filter media as well as to shake off all of the D.E. from the fingers when its time to backwash.
What kind of bolt pattern does Hayward EC filter have?
Depending on how old your Hayward EC filter is will determine if you have a bellyband or a bolt pattern. The older Yellow Perflex tanks had a bolt pattern with many bolts. The newer Gray Perflex tanks now have a bellyband with just one bolt you will have to remove or tighten.
