Why do I feel light headed after hot tub?

Since the water in a hot tub is a higher temperature than your normal internal temperature, staying in a hot tub too long can cause you to overheat and experience symptoms like light-headedness, dizziness, or nausea.

Do you need GFCI protection for an indoor hot tub?

GFCI protection must be provided for the outlet supplying a self-contained indoor spa or hot tub, or supplying a packaged spa or hot tub equipment assembly, or any field-assembled spa or hot tub. Because this rule applies to all outlets and not just receptacle outlets, a hard-wired indoor spa or hot tub requires GFCI protection [680.44].

What are special provisions for outdoor spas and hot tubs?

Electrical installations for outdoor spas and hot tubs must comply with Parts I and II of Art. 680 along with the special provisions included for outdoor spas and hot tubs in Part IV [680.40]. The special provisions in Part IV for outdoor installations are:

How to troubleshoot an issue with your spa?

To troubleshoot an issue with your spa, locate your specific problem in the chart below to help determine a probable cause, and then apply the right solution. Do you need to call a professional technician? Do you need to call a professional technician? Adjust the total alkalinity and pH.

Where is the control panel on my hot tub?

For a control panel that is built into the hot tub if you have a look inside the service bay of the hot tub you will probably see that it is also connected to the hot tub via a cable which will no doubt be plugged in somewhere. Again check for corrosion.

What is the error code for the spa?

PSoL = Pressure switch open with low pump. PSoH = Pressure switch open with high pump. ToE = Time out error. Rare system error. Spa unusable. Contact ACC. OHH = Overheat. Spa has shut down. One sensor has detected 118º Fat heater. OHS = Overheat. Spa has shut down. One sensor has detected 110ºF. SnA = Spa is shut down.

How often should you take your child out of the spa?

According to the Association of Pool & Spa Professionals, you should drop the temperature to 98 degrees F or lower and take your child out of the spa every fifteen minutes at this temperature to give them a break from the heat. During these breaks, give your children a drink of water so that they stay hydrated.

What does Th1 / 39 Mean on a spa?

SE = Spa operating in Standard-in-Economy Mode. th1/39 = On startup indicates temperature probe problem. th2/current temperature = On startup indicates temperature probe problem. OH = Overheating, water over 112° F. System will restart when temp. drops.