Why did my hot tub lose power?
Faulty Wiring Incoming wires can be damaged from heat or rodents, or you could have loose connections or wires touching each other. This will often cause a breaker to trip or a fuse to blow, but not always. Shut off all power before touching or replacing any damaged spa wiring.
What to do if your hot tub loses power?
If this restores power to your tub temporarily before the breaker is tripped again, consult an electrician – the problem is likely with your breaker and not your spa. If this does not fix the problem, check the GFI switch. The Ground Fault Circuit Interrupter (GFCI) is essential for maintaining a safe spa.
Why does my hot tub control panel keep blinking?
If there is any condensation, dry it off. A blinking red light on the control panel may indicate it needs to be reset. For most models, you will need to turn off the power to the spa for a minute or two and then turn it back on again. Turn on the lower amp breaker first if you have a hot tub powered by 240 volts.
Why are there no lights on my hot tub?
If you still have no indicator lights on your control panel, look underneath for lights on the spa pack. For a control panel that is unresponsive with no LEDs or temperature reading, check the wiring harness from the spa pack to the circuit board for a loose connection or damaged wire.
Where is the circuit breaker on my hot tub?
Check the main circuit breaker that provides power to the spa. This may be located in the home main panel, or inside a smaller panel near the hot tub. To reset a circuit breaker, first push it towards OFF, and then flip it back to ON.
What should I do if my hot tub wont turn on?
Turn on the lower amp breaker first if you have a hot tub powered by 240 volts. If it is 120 volts of household power, simply unplug it and then plug it back in after a couple of minutes.
If there is any condensation, dry it off. A blinking red light on the control panel may indicate it needs to be reset. For most models, you will need to turn off the power to the spa for a minute or two and then turn it back on again. Turn on the lower amp breaker first if you have a hot tub powered by 240 volts.
Check the main circuit breaker that provides power to the spa. This may be located in the home main panel, or inside a smaller panel near the hot tub. To reset a circuit breaker, first push it towards OFF, and then flip it back to ON.
Can a high limit switch shut down a hot tub?
In some spas, the heater’s high limit switch can cause a complete power shut down. But this is what it’s meant for! The purpose of a high limit switch is to protect spa equipment (and you!) from harm.
