Why are there flashing lights on my spa pack?
Sometimes the spa pack controls will display error codes or flashing lights. When this happens, the owner needs to do a bit of troubleshooting to fix the problem. Loosen the two screws that hold the cover onto the control pack. Lift the cover off to reveal the LED board. Check the LED board to see if there are three flashing dots on it.
What to do if your hot tub has an error code?
In some instances it may be more prudent to contact a local hot tub service company to assess and repair the spa pack as some diagnose procedures require special equipment. Please note that the Balboa Error Codes cover all circuit board manufactured by Balboa including Cal Spa, Marquis Spa, Master Spa and many others.
Do you use the same troubleshooting techniques at the spa?
DISCLAIMER: We at the Spa Care Center use the same troubleshooting techniques that have been provided to you and are fully confident that they work. But, when dealing with water and electricity, it always provides a danger that must be respected.
What does the orange light on a spa side control mean?
These are called Spa Side Controls, they have built in air buttons and orange indicator lights. One of the indicator lights says heater, this light comes on regardless if the spa is heating or not. Do not troubleshoot using this light, it could confuse you. Why Does The Hi Limit Switch Trip? The #1 reason is filter related.
When to use Spa when temperature is flashing?
Do not use spa when temperature is flashing or the OH message is displayed. HLoH = Hi Limit Over Heat. Hi limit sensor is disconnected or shorted or the spa temperature is above 112° F. SEoP = Sensor open or disconnected. Heater disabled but the spa is operational. SESH = Sensor short, nonfunctional.
What does it mean when spa light is blinking?
SnA = Spa is shut down. Sensor plugged into jack A is not working. Snb = Spa is shut down. Sensor plugged into jack B is not working. SnS = Sensors out of balance. If alternating with temp, may be temporary condition. If display shows only this message (blinking) spa is shut down.
What are the error codes on the spa side?
Flow Switch (heater is deactivated. Pump may also be deactivated). Panel sensors have been pressed too many times in a short period of time. Circuit Board temperature has exceeded acceptable limit. Freeze protection. No action is necessary. Freeze protection. No action is necessary. Communication between the panel and circuit board is faulty.
What does blinking red light on hot tub control panel mean?
Blinking Red Light. A blinking red light on the control panel may indicate it needs to be reset. For most models you will turn off the power to the spa for a minute or two and then turn it back on. Turn on the lower amp breaker first if you have a hot tub powered by 240 volts.
