Why are the lights flashing on my hot tub?
It also provides a diagnostic function–a blinking power indicator indicates that the heater high limit has tripped, meaning that either the spa water is above its acceptable temperature range, or a malfunction has occurred within the spa (such as low circulation due to clogged filters).
What does it mean when your hot tub light is blinking?
Blue Logo “Power” indicator blinking = Heater high-limit thermostat tripped. • Disconnect power for at least thirty seconds to reset heater high limit. If it will not reset, check for clogged filters. If tripping continues, call for service. Sn1 = Nonfunctional high temperature sensor.
When to use the spa and hot tub light?
The low speed pump or circ. pump will operate continuously until the temperature rises above 45° F. OH = Over heat. The spa is at a temperature above 108° . Do not use spa when temperature is flashing or the OH message is displayed.
What are the error codes for a hot tub?
1) Hot Tub Error Codes (Alphabetical) * * * (3 flashing dots under temp displa Flow/Pressure switch either Open or Clos * * * (as above, & red LED lit up on boa High Limit Fault – – – , – – – ‘Watchdog’ – 48C reached, electronic fau – 01 Hi-Limit fault – 02 Temp sensor fault
Are there any problems with my hot tub?
Hot Spring ® spa systems are reliable and will last a long time with regular maintenance, but issues do sometimes arise. To help set you on the right track toward fixing minor hot tub problems with jets, pumps, heaters, electrical systems, controls, and water quality, we’ve created an easy-to-follow chart below.
What does blinking red light on hot tub control panel mean?
Blinking Red Light. A blinking red light on the control panel may indicate it needs to be reset. For most models you will turn off the power to the spa for a minute or two and then turn it back on. Turn on the lower amp breaker first if you have a hot tub powered by 240 volts.
What does it mean when spa light is blinking?
SnA = Spa is shut down. Sensor plugged into jack A is not working. Snb = Spa is shut down. Sensor plugged into jack B is not working. SnS = Sensors out of balance. If alternating with temp, may be temporary condition. If display shows only this message (blinking) spa is shut down.
What should I do if my hot tub wont turn on?
Turn on the lower amp breaker first if you have a hot tub powered by 240 volts. If it is 120 volts of household power, simply unplug it and then plug it back in after a couple of minutes.
