Why are the check salt and inspect cell not flashing?
Both “Check Salt” and “Inspect Cell” LEDs stay on * Disconnected the T-15 cell and visually inspected it. No scaling that I can see, so I put it back * Holding down diagnostic button does not reset anything – the “Inspect Cell” LED is not flashing, it remains illuminated, thus why I cannot reset it for some reason. * T-15 cell is relatively new.
How to reset check salt and check cell lights?
I went to my Aqua Rite box and looked to see what it was reading. When the system came and flow was established, the “check salt” and the “check cell” lights both flashed continuosly. I reset the check cell light by holding down diagnostic button. The check salt never stopped flashing. The salt readout on the digital display was 2300.
How can I check the salt level in my Pool?
Check Cell Light blinks as well as the Low Salt light. The check cell light can be shut off by holding the diagnostic button for 3-sec (comes back on next time pump/system is started). The display reads a salt level of 2600 but it is actually 3200 verified twice by pool store.
What should the check cell salt level be?
If it’s over 2600-2700 the check salt level may be related to the check cell light. It could mean your cell is failing but surely not if it’s only four months old. I hope your solution is this simple. I was told the salt level should be between 2800-3200. The salt level is currently 3200 and all other levels are within range.
When does the check Salt Light Come On?
First, check the display salt reading – if it’s 2,700 ppm or lower, the check salt light will come on. We always recommend an independent salt level test. If the salt level is fine, inspect the Cell and clean if necessary.
Both “Check Salt” and “Inspect Cell” LEDs stay on * Disconnected the T-15 cell and visually inspected it. No scaling that I can see, so I put it back * Holding down diagnostic button does not reset anything – the “Inspect Cell” LED is not flashing, it remains illuminated, thus why I cannot reset it for some reason. * T-15 cell is relatively new.
How to reset aquarite salt chlorination inspect cell light?
Reset AquaRite Salt Chlorination Inspect Cell Light. If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
Check Cell Light blinks as well as the Low Salt light. The check cell light can be shut off by holding the diagnostic button for 3-sec (comes back on next time pump/system is started). The display reads a salt level of 2600 but it is actually 3200 verified twice by pool store.
