Why are my salt generator check salt and inspect cell lights staying on?
If both the “check salt” and the “inspect cell” lights stay on, it most likely means that no chlorine is being produced at this time and your salt level fell below 2300 ppm. Once your water has been tested, add the salt to your pool to bring the levels back to the recommended 2800 to 3200 ppm.
How do you reset the check on a salt light?
Reset AquaRite Salt Chlorination Inspect Cell Light If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
Why is my salt cell blinking green?
The setting on your chlorinator may be set too low, each pool is different, it is important to test the water weekly and adjust the percentage according to your inground swimming pool’s needs, also the newer chlorinators can do under 10% amounts so if the lights are flashing green in the area indicating percentage then …
When does the check salt and inspect light stay on?
Your chlorine generator is still producing chlorine at the moment, which is a good thing. This is more of an indicator light than anything else. The Check Salt & Inspect Cell LED’s will stay ON when: The salt level is 2300 ppm or less and no chlorine is generating. Step 1: Check your system to confirm that you have programmed the correct cell size.
How to reset check salt and check cell lights?
I went to my Aqua Rite box and looked to see what it was reading. When the system came and flow was established, the “check salt” and the “check cell” lights both flashed continuosly. I reset the check cell light by holding down diagnostic button. The check salt never stopped flashing. The salt readout on the digital display was 2300.
Can a check cell light be shut off?
Check Cell Light blinks as well as the Low Salt light. The check cell light can be shut off by holding the diagnostic button for 3-sec (comes back on next time pump/system is started). The display reads a salt level of 2600 but it is actually 3200 verified twice by pool store. The Salt generator cell was checked at Pool Store and no errors.
What should the check cell salt level be?
If it’s over 2600-2700 the check salt level may be related to the check cell light. It could mean your cell is failing but surely not if it’s only four months old. I hope your solution is this simple. I was told the salt level should be between 2800-3200. The salt level is currently 3200 and all other levels are within range.
Your chlorine generator is still producing chlorine at the moment, which is a good thing. This is more of an indicator light than anything else. The Check Salt & Inspect Cell LED’s will stay ON when: The salt level is 2300 ppm or less and no chlorine is generating. Step 1: Check your system to confirm that you have programmed the correct cell size.
I went to my Aqua Rite box and looked to see what it was reading. When the system came and flow was established, the “check salt” and the “check cell” lights both flashed continuosly. I reset the check cell light by holding down diagnostic button. The check salt never stopped flashing. The salt readout on the digital display was 2300.
If it’s over 2600-2700 the check salt level may be related to the check cell light. It could mean your cell is failing but surely not if it’s only four months old. I hope your solution is this simple. I was told the salt level should be between 2800-3200. The salt level is currently 3200 and all other levels are within range.
Check Cell Light blinks as well as the Low Salt light. The check cell light can be shut off by holding the diagnostic button for 3-sec (comes back on next time pump/system is started). The display reads a salt level of 2600 but it is actually 3200 verified twice by pool store. The Salt generator cell was checked at Pool Store and no errors.
